Toyota Corolla - Recent Questions, Troubleshooting & Support
Toyota 5afe head bolts torque
Toyota 4A/ 5A-FE Cylinder Head Torque:
(a) Apply a light coat of engine oil on the threads and under the heads of the cylinder head bolts.
(b) Install the plate washer to each cylinder head bolt.
(c) Install and uniformly tighten the ten cylinder head bolts in several passes in the sequence.
Torque: 60 N-m (610 kgf-cm, 44 ft-lbf)
HINT: Cylinder head bolts are in length of 90 mm
(3.54 in.) and 108 mm (4.25 in.). Install the 90 mm
(3.54 in.) bolts (A) in intake manifold side positions.
Install the 108 mm (4.25 in.) bolts (B) in exhaust
manifold side positions.
What is P2716 code for a 2006 Toyota Corolla mean?
There is currently a recall going on for this problem. You can likely get your money back on the prior repairs as well. See this link
http://www.toyota.com/recall/corolla-matrix.html. On the left-hand side, you can click to take you to put in your VIN and see if your vehicle is included. My 2007 vehicle IS included, and I just had the check engine light come on and have been experiencing rough shifting for about 6 months. When the light came on yesterday, it was extremely rough jerky shifting. The light went off today. Took it to Autozone and got same code P2716. Toyota has assigned me a case number, but I won't get a call back until Monday or by close of biz on Tuesday. This problem can cause your car to not start, or to shut down while driving. YIKES! The person I talked to at Toyota acted a little too nonchalant about the whole deal. Telling me to just wait for the call that I will get. She said most dealers would not have the part needed to fix this. According to what I have read. That is the reason why Toyota is not sending out the notification letters to the affected parties until mid-September. Check out all the info and good luck. I am a little bit p.o'd about this right now. - Natalie
Toyota corolla radio wiring diagram
The back of the stock radio should have a description of what wires are what to help with replacement. Or you can go to your local parts store and buy a chilton manual for your car, they have wiring diagrams in them.
Low beam headlights don't work
I have e-mailed you 2 .pdf files, one is the complete headlamp diagram, and the other is the relay locations. Please advise if you need further assistance.
Toyota Ed
Valve clearances toyota 7afe engine
Toyota 7A-FE valve clearance (measured cold):
- Inlet: 0.15 to 0.25 mm (0.006 to 0.010")
- Exhaust: 0.25 to 0.35 mm (0.010 to 0.014")
Source: https://workshop-manuals.com/toyota/corolla_sedan_4-door/l4-107.5_1762cc_1.8l_dohc_(7a-fe)/maintenance/tune-up_and_engine_performance_checks/valve_clearance/system_information/specifications/page_815/
Not finding what you are looking for?