Ignition Coil
Removal & Installation
4.2L Engine
To Remove:
To Install:
Each sparkplug wire must be connected to its correct ignition coil terminal.
4.6L and 5.4L Engines
To Remove:
CAUTION
Each sparkplug wire must be connected to its correct ignition coil terminal.
To Install:
NOTE: Ensure that the ignition coil spring is correctly located inside the ignition coil boot and that there is no damage to the tip of the boot.
SOURCE: how do you install coil pack on 98 camaro v6 3800
#1 disconnect neg. bat cable. #2 unplug both leads from the coil your changing. #3 remove both mounting screws and pull up and remove on it to remove it...reverse to install. be careful when removing the screws they're small and you dont want to drop them. hope this helps.
SOURCE: 2002 C240 V6 How can I check the coil
swap them if possible why you have engine light misfire
SOURCE: New coil pack, ran good for a week. Replaced pack,
sounds like a bad fuel pump .. you can have it pressure and volume tested .. some ford fuel pumps use plastic impellers that are damaged if you run out of gas ...
866 views
Usually answered in minutes!
×