My AC for mazda protege 1997 is blowing hot air only; I was told the car had an electrical problem because the AC doesn't come on; but there was pressure when the gauge was attached. How can I solve the electrical problem? Thanks a million

Question 1

0helpful

1answer

Center vents not blowing air

Vacum it up

Mar 27, 2013 • 1997 Mazda Protege

0helpful

1answer

I have a 1997 mazda protege with a coolinf fan prob. The fans work when I turn on the AC but do not work when the engine gets hot at idleing speeds. I replaced radiator and thermastate and also cooling...

No, the fans have separate relays. You have to use the wiring diagram to sort it out. The pcm turns on the cooling fan relay with a ground signal on a purple/black wire when the temp sensor signal rises too high.

Oct 31, 2017 • 1997 Mazda Protege

1helpful

1answer

My 1997 Mazda Protege heater does not blow air, i replaced and tested blower motor, resistor and fuses inside the cab. Still nothing

Before replacing the blower motor, you should have checked the motor's input wiring loom for power.
Do you have power here?

If you don't have power, then you need to check your blower switch output wires.

Nov 04, 2012 • 1997 Mazda Protege

0helpful

1answer

Air conditioner most of the time blows hot air, espesially after car is hot. Also the RPM of the car dont go up when airconditioner on

keep all the doors of car open for 4/5 minutes before you start driving ,
this avoids hot air blown when ac started.

Also AC runs on battery & compressor takes heavy current while starting & running to ,this causes RPM to go down.
Also check with local automaker for battery capacity remaining.

Jul 06, 2012 • 1995 Mazda Protege

0helpful

1answer

1997 Mazda Protege Air Conditioner blows cool air initially, but after 10 - 15 minutes (approximate) of use, it begins blowing hot air. I had freon charged/replinished last week. Thought that would...

1--BLEND DOOR NOT SEALING PROPERLY
2--FRONT CONDENSOR PLUGGED UP WITH DEBRIE
3--FRONT CONDENSOR NOT TRANSFERING HEAT (SPRAY WITH GARDEN HOSE WHILE ---RUNING SYSTEM IF IT WORKS BETTER CONDENSOR MAY HAVE TO GET CHANGED
4--WRONG CHARGED WEIGHT IN SYSTEM
5--COMPRESSOR CYCLE TIME NOT CORRECT
6--IF COOLANT CABLE VALVE ON SYSTEM MAY NOT BE CLOSING CORECTLY
---TRY PINCHING OFF THE COOLANT LINES TO HEATER CORE

May 31, 2011 • 1997 Mazda Protege

0helpful

1answer

Warm air blows in my mazda protege 5 even when the fan is off and the heat off. It gets hot. I have to put ac on when its cold out to keep the heat off. Any ideas?

problem with one of the flaps ,just turn vent control to screen so it blows onto screen instead,or put a clamp on the water hose

Dec 12, 2009 • 2002 Mazda Protege

1helpful

2answers

Air conditioner blows hot air inadvertantly.

possibl ac compressor clutch problem,cooling fan at rad not working so ac goes into high press mode and turns off(so it doesn,t blow system apart,built in safety)not enough r134 in system(low charge)

Sep 19, 2009 • 1997 Chrysler Concorde

0helpful

1answer

My mazda 2002 protege is running hot when ac is on

your car temp is hot because the air-con automatic fan/cooler on the condenser is not functioning. check the electrical connections from the switch as well as from the compressor. otherwise check the thermostat. the fan should run when the aircon is switched on.

Jun 23, 2009 • 1993 Mazda Protege

0helpful

1answer

How to replace the serpentine belt of protege 5 2002, also need the routing diagram

Posted by Asker under 1997 Mazda Protege for their 2002 Mazda Protege 5.
Both are included Below

Click on the following free direct Link. It has the Belt Diagrams for the 1997 Mazda Protege with either the 1.5L DOHC In-Line 4-Cylinder or 1.8L DOHC In-Line 4-Cylinder Engines; along with various engine options (AC/No AC, etc.). Included are Instrucional Diagrams for loosening (for removal) and tightening (for replacement) using the Adjustment and Locking Bolts/Nuts.
http://www.2carpros.com/car_repair_information/year/1997/make/mazda/model/protege/1997_mazda_protege_drive_belt_routing_diagram.htm

Click on the following free direct Link. It has the Belt Diagrams for your 2002 Mazda Protege 5 2.0L DOHC In-Line 4-Cylinder Engine; along with various engine options (AC/No AC, etc.). Included are Instructional Diagrams for loosening (for removal) and tightening (for replacement) using the Adjustment and Locking Bolts/Nuts.
http://www.2carpros.com/car_repair_information/year/2002/make/mazda/model/protege5/2002_mazda_protege5_drive_belt_routing_diagram.htm

Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!

Apr 13, 2009 • 1997 Mazda Protege

0helpful

1answer

NO HEAT 94 MAZDA PROTEGE

this is a blend door problem it is either vacuum or servo motor driven and this door switches from cold side to hot side this seams like this is you problem. Hope this helps you.

Jan 18, 2009 • 1995 Mazda Protege

Question 2

Jonah Oneal

Mazda Master 14,092 Answers
Posted on Jun 25, 2010

Jonah Oneal

Mazda Master

Joined: Mar 17, 2009

Answers

14092

Questions

0

Helped

7234958

Points

44533

CHECK THE AC COMPRESSOR CLUTCH FUSE AND RELAY.IF BOTH GOOD YOU HAVE OPEN AC CLUTCH COILOR THE COMPRESSOR FAULTY.IF COMPRESSOR CLUTCH COIL IS OKAY AND COMPRESSOR GOOD.YOU HAVE ELECTRICAL PROBLEM AT THE AC MODE SWITCH.NOT ALLOWING AC AIR DOOR OPEN.

Answer 2

roti

Contributor 6 Answers
Posted on Oct 07, 2019

roti

Contributor

Joined: Oct 07, 2019

Answers

6

Questions

0

Helped

2760

Points

18

I quit working my desk job and now,,,I 'm making $97/Hr working from home by doing this simple online home jobz.i earn $15 thousands a month by working online 3 Hour par day.i recommended you try it.you will lose nothing.just try it out on the following website and earn daily...go to this site home media tech tab for more detail thank you.......http://www.Geosalary.com

Answer 3

Anonymous

Expert 56 Answers
Posted on Jun 25, 2010

Anonymous

Expert

Joined: Jun 25, 2010

Answers

56

Questions

0

Helped

36408

Points

184

Dear Madam or Sir,

if your car is equipped with an automatic climate control the problem will be:

a defective temperature flap servo motor or a faulty indoor temperature sensor.

Elseaway a defective expansion valve will be the cause of your malfunction.

Related Topics:

Trustworthy Expert Solutions

My AC for mazda protege 1997 is blowing hot air only; I was told the car had an electrical problem because the AC doesn't come on; but there was pressure when the gauge was attached. How can I solve the electrical problem? Thanks a million

3 Answers

Jonah Oneal

roti

Anonymous

Add Your Answer

Attachments: Added items

Related Questions:

Center vents not blowing air

I have a 1997 mazda protege with a coolinf fan prob. The fans work when I turn on the AC but do not work when the engine gets hot at idleing speeds. I replaced radiator and thermastate and also cooling...

My 1997 Mazda Protege heater does not blow air, i replaced and tested blower motor, resistor and fuses inside the cab. Still nothing

Air conditioner most of the time blows hot air, espesially after car is hot. Also the RPM of the car dont go up when airconditioner on

1997 Mazda Protege Air Conditioner blows cool air initially, but after 10 - 15 minutes (approximate) of use, it begins blowing hot air. I had freon charged/replinished last week. Thought that would...

Warm air blows in my mazda protege 5 even when the fan is off and the heat off. It gets hot. I have to put ac on when its cold out to keep the heat off. Any ideas?

Air conditioner blows hot air inadvertantly.

My mazda 2002 protege is running hot when ac is on

How to replace the serpentine belt of protege 5 2002, also need the routing diagram

NO HEAT 94 MAZDA PROTEGE

Not finding what you are looking for?

1997 Protege

Center vents not blowing air

Ask a Question

Check Out the Latest Top Trucks Report!

Top Mazda Experts

ZJ Limited

Ronny Bennett Sr.

Thomas Perkins

Are you a Mazda Expert? Answer questions, earn points and help others

Manuals & User Guides

1997_Prtg...

. 1997 Protege Manual

Related Topics:

Trustworthy Expert Solutions

My AC for mazda protege 1997 is blowing hot air only; I was told the car had an electrical problem because the AC doesn't come on; but there was pressure when the gauge was attached. How can I solve the electrical problem? Thanks a million

3 Answers

Jonah Oneal

roti

Anonymous

Add Your Answer

Attachments: Added items

Related Questions:

Center vents not blowing air

I have a 1997 mazda protege with a coolinf fan prob. The fans work when I turn on the AC but do not work when the engine gets hot at idleing speeds. I replaced radiator and thermastate and also cooling...

My 1997 Mazda Protege heater does not blow air, i replaced and tested blower motor, resistor and fuses inside the cab. Still nothing

Air conditioner most of the time blows hot air, espesially after car is hot. Also the RPM of the car dont go up when airconditioner on

1997 Mazda Protege Air Conditioner blows cool air initially, but after 10 - 15 minutes (approximate) of use, it begins blowing hot air. I had freon charged/replinished last week. Thought that would...

Warm air blows in my mazda protege 5 even when the fan is off and the heat off. It gets hot. I have to put ac on when its cold out to keep the heat off. Any ideas?

Air conditioner blows hot air inadvertantly.

My mazda 2002 protege is running hot when ac is on

How to replace the serpentine belt of protege 5 2002, also need the routing diagram

NO HEAT 94 MAZDA PROTEGE

Not finding what you are looking for?

1997 Protege

Center vents not blowing air

Related Topics

Ask a Question

Popular Questions

2003 Mazda protege had rough idle and wants to stall when I stop.

Fuse box diagram

How to change a thermostat in mazda protege 2003

Code P1195

TIMING BELT ALIGNMENT ON 2000

Check Out the Latest Top Trucks Report!

Top Mazda Experts

ZJ Limited

Ronny Bennett Sr.

Thomas Perkins

Are you a Mazda Expert? Answer questions, earn points and help others

Manuals & User Guides

1997_Prtg...

. 1997 Protege Manual