SERPENTINE BELT DIAGRAM - 1998 Ford Windstar

SOURCE: serpentine belt diagram:

if yours has the 3.8L then here is the diagram. Hope this helps
~ Zach

SOURCE: serpentine belt diagram:

The belt routing diagram is located on the top radiator cross member by the hood latch. You should see it when you open the hood. If it is not there, all Chrysler, Dodge, and Plymouth minivans, from 1993 to at least 1999, used the same 3.3L engine setup, so find someone with one and look for the diagram where I described.

Harvey N Tawatao

• 3854 Answers
• Posted on Apr 19, 2009

SOURCE: serpentine belt diagram

The serpentine belt routing should be labeled on your radiator shroud. Look around the engine compartment like the hood or radiator fram suport and there should be a label with the the belt routing.
Good luck and hope this helps

SOURCE: diagram for 1998 buick lasabre serpentine belt

I found the diagram in my owner's manual.
I replaced the belt on mine just 2 days ago. All you need to do is remove one bolt from the lower motor mount and remove the spacer. After you relieve the belt tensioner, the belt will slip right through the gap. Don't forget to support the engine before removing the bolt. As a backup I took a photo of the belt with my digital camera beforehand... just in case.

SOURCE: serpentine belt diagram

Go to this link:

http://www.mvreader.com/multiview/dayco/index.php?bgInterchange=1&l=n

Enter your vehicle information. Then click on Belt Routing Diagram, It will pull up a picture of the diagram.