It's behind the a/c compressor just above the oil pan on the passenger side of the block on a 4.6 Romeo engine
SOURCE: 1992 pontiac grand prix cranks but will not start
there is a module that the coil pacs plug into, it may be bad or have a bad connection
SOURCE: 1997 GMC CRANKS NO START
Go to a library that has a set of the factory service manuals (not Chlton's or Haynes or Motor's). The FSM's will give you all the trouble hotting charts that the dealer techs use.
SOURCE: Crank sensor location 1999 dodge durango
the crank sensor is located passenger side back of the engine were the trans and engine come together .there are 2 - 13mm.bolts that bolt to top of the engine.
SOURCE: no spark,new coil still no spark,crank sensor? 95 dodge ram 5.2 l
Could possibly be the ECM or computer it may be the crank sensor. The crank sensor is probably the cheepest so I would start there. Since it sound like you may be throwing parts at this, since you cant drive it to have a diagnostic done and you can't have the crank sensor tested, I would buy a used one from a junk yard to see if that is the problem to save a little money since you may have to buy somthing else if that does not work. Good luck
For no spark problem,click the link below :---Car has
no spark?
http://schematicsdiagram.blogspot.com/2011/06/car-has-no-spark.html
Crank sensor to module to coil pack to plugs. There may be a failing component. I would check Crank Sensor first. If you are getting spark to all cylinders, then rule out coil packs, if only spark to one or two cylinders, then replace faulty pack.
49 views
Usually answered in minutes!
Check fuses first and relays and check for spark at each plug wire //fuses to check € coils , fuel injection , idle air control valve,throttle position sensor, fuel pump ,pcm etc. Plus there relays ok
×