Check fuel level first,possible fuel pump failure
SOURCE: 1993 JEEP GRAND CHEROKEE LAREDO IM TOTALLY BAFFLED
Back up a minute...Do you have spark from the coil wire? (juice from coil) If so, change or check rotor and cap (wires do not all go bad at same time so unless they are wet, likely at least good enough to start engine)
SOURCE: 1993 JEEP GRAND CHEROKEE LAREDO- TRUCK WONT
OK...I have a 93 outside...one diagram I have shows an ignition module next to coil...but there is none on mine, (4.0 engine)
Two items to check are crank sensor and cam sensor inside distributor. Test procedure can be found in just about any manual including haynes.
You will need a decent volt/ohm meter to do testing. You can also check codes by turning ignition switch on/off three times, leaving it on the third time. Check engine will flash code #'s (ex: one flash, pause two flashes= the number twelve.then followed by a longer pause then another set of flashes etc.)
SOURCE: 1993 Jeep Grand Cherokee Laredo wont drive when put into gear
No, not with out a lot of work. Electronics are most likely different on the 2 also.
SOURCE: my jeep grand cherokee laredo, 2000, wont start...
engine turns over so starter is ok. chrysler computer can cause this situation. Many computer module warranties were extended by chrysler because of problems. check with dealer. They can scan computer to verify. Make sure you try starting fluid first to see if fuel pump is out. have someone spray into air filter box while trying to start car. if pump is bad it will start.
SOURCE: turn the key and the
Try swapping your wiper and starter relays. If it starts that way, your starter relay is bad.
75 views
Usually answered in minutes!
×