I have an 2007 Hyundai Entourage. I'm getting a po018 code the wire has broken off from the Sensor. I can't locate the senor on the engine. Can you help with the location so I can replace it?

Question edited for clarity.

Some ideas in the link

https://www.google.com/search?q=2007+Entourage+tailgate+latch+won%27t+open

..

The bank that contains cylinder number one is bank 1. On your car bank one contains cylinders 1-3-5 and bank 2 contains cylinders 2-4-6. The 02 sensor before the CAT. is the Upstream sensor or Sensor 1. The sensor after the CAT. is the Downstream sensor or Sensor 2. Any questions please write back.

Here is a picture of the switch. Apparently there is only an oil light in the vehicle, so it is a switch and not a "sensor". The second picture shows the engine. The marked "F" is the location of the switch.

look at the junction between the engine and the gearbox/ transmission, it may be fitted low down. It has to be there in order to drive the flywheel to start the engine

- Faulty Throttle Position Sensor (TPS)
- Throttle Position Sensor (TPS) harness is open or shorted
- Throttle Position Sensor (TPS) circuit poor electrical connection
- Faulty Powertrain Control Module (PCM)
- Faulty Mass Air Flow (MAF) sensor
- Faulty Manifold Absolute Pressure (MAP) sensor

Faulty Accelerator Position Sensor(APS)
- Faulty APS+Brake
- Faulty APS + Vehicle speed sensor
- Faulty APS + Vehicle speed sensor + Brake
- Faulty Electronic Throttle Control(ETC) Items(TPS or ETC motor etc)
- Faulty Powertrain Control Module (PCM)

Check you're manual if it's not broken?

While I was changing out struts on my 2007 Entourage, I had to remove the wiper motor. It was easy to do it, 4 - 10mm bolts and it was out.

Getting to the motor took a little more work but is not impossible. You have to remove the windshield vent cover (not sure what it's called), it's located at the bottom of the windshield, and when the hood is up, you can remove the wiper arms and those trim pieces and get to the motor easily.

This is a good general video that will show you how to roughly remove everything, granted this is a strut replacement video, but the beginning is what would be important to you: http://www.youtube.com/watch?v=UpSIv3mk98k
Hope that helps!

If the engine is still not warmed up yet and you take off like a bat out of hell, they will misfire occasionally. If it is a frequent problem change the spark plugs.

look at position of bulb inside lamp assy then open bonnet feel behind h/lamp at location of indicator bulb you will locat the bulb wire socket turn this socket anti clockwise slightly it will release the socket complete with bulb pull it out then fit new bulb make sure bulb is correct one! ie the locating bayonet pins are same ? then refit socket with new bulb in reverse sequence test working