Take it to ur local auto parts store and they will scan it for you free of charge.
SOURCE: my check engine light came on will that happen
No, there is an oil light usually red shaped like an old school oil can or just says "oil". The check engine light is just a warning from the many sensors in modern engines that monitor fuel, air quality in the exhaust and in the intake, to many other things. You can go to many auto parts stores and they have code readers that they will plug into the vehicle. Auto Zone, NAPA and Schucks are a few. They'll tell you specifically what the problem is usually for free, so you'll buy the part from them. I also suggest you get a repair manual for the vehicle so you can do some minor repairs yourself. Haynes and Chilton are the two I use and you can get them conveniently at the auto parts stores. Good luck to you
SOURCE: 2008 dodge nitro 3.7 engine. The engine missfires
Have it checked for trouble codes sounds like it could be an injector problem or something as serious as a loose rocker,maybe try a crank&cam shaft position sensors
SOURCE: 2008 dodge nitro change oil light how to turn off ...
Directions are in the book, but you would put the key in and turn it all the way, just don't start engine. Pump gas pedal all the way to the floor 3 times slowly, but it has to be with 10 seconds. Turn key off and when you start again, oil changed chime and warning should not be on. If it is, try again.
SOURCE: check engine light is on.
you'll need to pull the codes. There are hundreds of possibilities. With the code(s) you will be able to identify the problem a lot easier. Call around, some parts stores will pull codes for free. Shops will usually have a fee that includes the diagnostic time to figure out the cause of the code and determine the correct repair.
Some common things are loose gas cap or O2 sensor issues but like I said it could be any number of a hundred or so different things.
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
SOURCE: My dodge 2008 nitro brake light switch was changed and now my car won't start.
take it to the ppl that changed it and have them fix it or check your battery,switch,starter or solenoid
113 views
Usually answered in minutes!
×