The power drivers bucket seat in my 2008 Chrysler Sebring moves when I brake or accelerate. The power switch works fine

SOURCE: driver side power window stopped working

The door panel is held on by plastic clips and 5 screws. 3 screws are on the bottom and 1 in the pull cup and 1 in the inner door handle.Then grab one of the corners and give a small tug, when you get some of the clips to pop out then proceed around the whole panel. To replace the panel take the clips out of the door with a fork and slide them back into the panel and then line it up on the door and use your hand like a hammer and bang the panel back on. Hope this helps

Mike Butler

• 6674 Answers
• Posted on Mar 27, 2009

SOURCE: 2003 Chrysler sebring wiring diagram for power and heated seats

Do some checking if you haven't already, the harness may already be there under carpet. If not, you may have to sweet talk a service guy at dealership for the print you need, or try www.alldata.com.

SOURCE: driver's power seat not working properly on 2004 tahoe

it sound like you need to replace seat control switch

SOURCE: 2002 chrysler sebring, the drivers tail light,

Is your lense cracked where water can get into the housing? Are you absolutely certain that you are replacing it with the correct bulb? Are you using a good name brand bulb like Wagner or Sylvania? or some off-brand cheap bulb made in China?

SOURCE: 1999 Chevrolet Silverado power bucket seats both seats move.

The problem is the track. You can find replacement tracks on EBAY for about 180.00 for driver side.