Are you getting a check engine light? If so, the sensor is rarely the problem. You need to check that the timing chain didn't skip or stretch. If it did (which is a possibility with that Honda motor 2002-2006), it needs to be serviced before driving it. If the timing's off, you can bend the valves and it's over.
SOURCE: camshaft position sensor location
crank sensor is a component used in an internal combustion engine to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control ignition system timing and other engine parameters. Before electronic crank sensors were available, the distributor would have to be manually adjusted to a timing mark on the engine.
The crank sensor can be used in combination with a similar camshaft position sensor to monitor the relationship between the pistons and valves in the engine, which is particularly important in engines with variable valve timing. It is also commonly the primary source for the measurement of engine speed in revolutions per minute.
Crank sensors in engines are usually comprised of magnets and an inductive coil. They are principally based on the Hall effect. Common mounting locations include the main crank pulley, the flywheel, or occasionally on the crankshaft itself.
Some engines, such as GM's Premium V family utilise crank position sensors which read a reluctor ring integral to the Harmonic Balancer. This is a much more accurate method of determining the position of the crankshaft, and allows the computer to determine within a few degrees the exact position of the crankshaft (and thereby all connected components) at any given time.
SOURCE: Where is the camshaft position sensor located-99 Chevy Lumina 3.1
It's held down by one bolt right above the timing chain cover. It's next to the head that's facing toward the front of the car.
SOURCE: How do I change Camshaft position sensor
THE CAMSHAFT SENSOR IS IN THE DISTRIBUTOR.
Testimonial: "you was very helpful thank you..."
SOURCE: Camshaft Position Sensor Location
IF U GO TO THE RIGHT SIDE OF THE ENGINE AND LOOK 4 INCHES BEHIND THE BELT IT WILL BE ON TOP OF THE TIMING COVER.THE WIRES WILL BE RED/WHITE,BLACK,BROWN/WHITE
SOURCE: Where is the camshaft position sensor located in a 2001 VW Passat
when you are looking at the engine pull off the plastic cover on top then the front cover that covers you timing belt there is a wire harness tha goes right to it in the left upper coner two ten mil bolts and it comes off careful not to drop bolts down in belt that could be bad. it is that easy
932 views
Usually answered in minutes!
×