It's on the left side of the transmission with the shift cable to see what it looks like go to rockauto.Com and look up your vehicle then go to electrical switch and relay section then back up lamp switch pictures are there
SOURCE: 2006 Ford Explorer "Oil Change Required" light is still on after changing the oil
IF YOU FIND THIS INFO USEFUL PLEASE RATE ME AS A FIXYA! THANKS
Oil Change Reset
A press of the OIL CHANGE RESET switch will allow you to
reset the oil life feature to 100% (or your Personalized Oil Reset
Percentage). After you have the oil changed, you must execute
the following procedure. Press the OIL CHANGE RESET switch
and hold for five seconds as the M/C counts down for five
seconds. After a successful reset the Message Center will display
“OIL LIFE RESET TO 100%.” If you have established a
Personalized Oil Reset Percentage, the display will show that
percentage instead of 100%. To ensure accurate oil life
indicators, perform this reset procedure only after an oil change.
Your Personalized Oil Reset Percentage allows you to establish a
smaller oil change interval than the manufacturer’s
recommended interval. To establish your Personalized Oil Reset
Percentage perform the following procedure:
1. Press and hold the OIL CHANGE RESET switch and press
the RESET switch while the display is still counting down
the 5 seconds to reset. The display will change to “START
OIL LIFE AT XXX%.”
2. Press the OIL CHANGE RESET switch until the displayed
percentage is the Personalized Oil Reset Percentage that you
desire. Your choices are 100%, 90%, 80%, 70%, 60%, 50%,
40% and 30%.
SOURCE: GEAR SHIFT INDICATOR LIGHT 2006 FORD EXPLORER
I had the same problem. They need to change the whole shift indicator assembly. Had mine fixed inn 30 minutes
SOURCE: Location of crank sensor on 2006 ford explorer
Here is the diagram, installation, and removal of the Crankshaft position sensor for the 2006 Ford Explorer 4.0L SOHC Engine: http://www.4shared.com/document/M_-IdBmP/2006_Ford_Explorer_40L_SOHC_Cr.html
Here is the diagram, installation, and removal of the Crankshaft position sensor for the 2006 Ford Explorer 4.6L Engine: http://www.4shared.com/document/xevDKaBb/2006_Ford_Explorer_46L_Cranksh.html
I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514
SOURCE: 2006 Ford Ranger 4'0 V^ fuel pump relay and/or
The reset button is on the passenger side floor at the corner where the dash meets the door.You'll need to pull down the corner of the carpet to see it.
362 views
Usually answered in minutes!
×