The belt tensioner is making a noise i want to replace it can you send me pictures showing how to replace it?
You can probably changed it without pictures. You can take the serpentine belt off, and to do that you actually turn that tensioner that you want to replace, which releases the tension on the Belt. Once you have the belt off there is one bolt to take off the tensioner arm. It all comes off in one unit, and the new one will come already assembled, with a new bolt, ready to disc boat right in. There was a little pain that needs to line up to make sure you get it in the right position, other than that there's nothing to it.
Testimonial: "is there a inner and outer?"
SOURCE: 91 buick regal 3.8L is making a loud clank noise in belt area
did you check all the pulleys for smooth operation and looseness? did you check that the crank pulley and damper are OK?
SOURCE: 1991 Buick Regal 3.8L Belt Tensioner
Remove belt and unbolt center pulley bolt. I believe it's a backward theaded bolt. Turn to the right to loosen.
SOURCE: 1997 Buick Regal fanbelt problem
buy a new tensioner assembley and idler pully and might as well get a new belt while your at it. you will need a 3/8 ratchet a 15 mm socket and a 13 mm socket there is one bolt holding on tensioner remove it discard old tensioner put new tensioner in place and tight bolt. second remove bolt from idler pulley discard old pulley put inton place and tighen bolt. next install belt fallow belt routing digram put head of 3/8 rattachet into hole on tensioner or on bolt head of tensioner pulley depending on style of tensioner and pull or push to create slack in belt push belt into groves on all pulleys and release tensioner
SOURCE: how to change the rear 3 spark plugs on a Buick regal LS 2002
You can try rotating the spark plug boot a little bit-not even a 1/4 turn-to break the seal between the plugand the boot. Then pull the boot wire off with a pliers on the metal boot shield. Once the boot has beet rotated on the plug, the shield helps to remove it.
SOURCE: how to remove belt tensioner on a 2002 buick regal l s 3.8l
disconnect battery first, unbolt alternator(3 bolts), cross bar bracket(2 nuts) unhook both heater hoses out of the connectors(each has a 7mm head bolt in them, then twist loose), remove belt, then there are 3 bolts holding it on the motor, has a plastic elbow to the intake and an o-ring seal male port that goes into the timing cover. gently pry back and forth to work it loose so not to break either the elbow or the port off. alot of times it seizes up in there. the elbow is a hat trick to get in and out also, just be patient and take your time
179 views
Usually answered in minutes!
×