SOURCE: Pontiac Bonneville(2000) oil pressure sending unit
The oil pressure sending unit is located behind the oil filter, Threaded into an aluminunm housing. It has wiring that plugs into the sending unit. The oil filter has to be removed and you will need a deep well socket and a 6 inch extension. Change the oil and the sending unit together.
SOURCE: oil pressure sending unit
Hi there;
Your looking foer the oil pressure sensor on the 2004 8.1L.
You will find it located directly behind the EGR valve threaded into the block just to the drivers side of the center bolt for the transmission to block connection.
Thanks
Farrout!
SOURCE: quits while driving replaced many suspected parts
try this, the next time it quits leave the key in on position and get a broom stick and go to the passenger side of the car. About straight in at the back of the door ,reach under with the broom stick and tap the plastic gas tank a few times, have someone try to start it or go start it yourself. Mine did this even after the garage checked it out and cleaned the tank. Come to find out dirt settles around the fuel pump and clogs it. They just blame the pump but in my case the pump was fine. I was told Alero used a very small fine mesh in the sock that goes in the fuel pump and they clog up. But most of the dirt was around the plastic guard around the fuel pump. See if this works and let us know. Good luck
SOURCE: where is the oil pressure sending unit located?
The pressure sending unit is located on the passenger side rear of the engine just above and slightly to the left of the filter and filter housing.
SOURCE: I keep getting a stop engine low oil pressure
Just wondering if you put in the correct amount of oil and tightened everything back up properly...
227 views
Usually answered in minutes!
×