SOURCE: how do i replace crank sensor on 2001 olds alero
the crank sensor is located beneath the intake between the starter and oil filter it has one small bolt in it remove the bolt and pull the sensor out and just stick the new one in put the bolt back in it and plug it up but make sure you disconnect the battery before you do anything that bolt is probably a 10mm or a 5/16 i hope this helps
SOURCE: 2001 Olds Alero oxygen sensor bank 1 P0135
p0135 indicates bank 1 sensor 1 which is before the cat.
SOURCE: Where is the front oxygen sensor located on my
Under hood , center, rear engine area, above exhaust pipe flange, mounted in exhaust manifold. May be behind a heat sheild that will have to be removed.
SOURCE: How do I install throttle
Hi,
I have a 2004 Alero ( similar procedure in your model as well ) and I just figured out today and replaced my
throttle position sensor. I'm not sure what the black plastic "box" is
called that is above the throttle assembly...but I had to remove that to
get to the throttle position sensor underneath. If you can locate the
two wires that control the throttle assembly...then the throttle
position sensor is on the other side of the throttle assembly. I had to
remove the large tube that went from the air filter to the black plastic
"box" above the throttle assembly. Also disconnected anything else
connected to that black plastic "box". Then pulled that "box" up and
right there on the left side of the throttle assembly was the throttle
assembly sensor. Here is a web page with a picture that helped me figure
out where it was :-
http://en.wikipedia.org/wiki/Throttle_position_sensor
http://www.ehow.com/how_4590680_replace-throttle-body-oldsmobile-alero.html
Let me know,if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!
195 views
Usually answered in minutes!
×