How to install egr valve on 2006 dodge grand

Yes clean it. Clean the holes in the intake also. A stiff wire in the intake will break anything loose. what you break loose will not hurt your engine. First just unplug the wire connector and plug it in. clear the codes. Some times it's just a bad connection.

Replace the EGR valve. Very common code.

Absolutely. You'll know if your EGR valve is stuck or malfunctioning because your car will experience symptoms like rough idle and bucking on acceleration.

cleaning is only a temporary fix as cleaning solutions removes the coating on the pindle and ruins the egr, buy a new one and you will fing it located on the intake near the throttle body

in addition to the valve there are other things to consider when trouble shooting the egr system. see thefolling link for more info.

http://www.aa1car.com/library/tps_sensors.htm

the EGR valve assembly should be in the back of the engine near the fire wall and the brake booster

a 1/4"10 mm swivel will break it loose then it sould only be finger tight i have never crossed one any tighter keep the top on tight until the bottom comes loose

IT IS LOCATED ON THE FRONT OF THE FRONT CYLINDER HEAD(BELT END) OF ENGINE..JUST ABOVE ALTERNATOR..2 BOLTS HOLD IT TO HEAD,A METAL TUBE COMES OFF IT..1 ELECTRICAL CONNECTOR..MORE LIKELY ELECTRICAL SIDE OF VALVE IS DEFECTIVE(SOLENOID)
..RECOMMEND REPLACING VALVE..ABOUT 120 BUCKS FROM DEALER..YOU WILL NEED A NEW TUBE GASKET AND NEED TO DISCONNECT BATTERY WHILE REPLACING..HAVE SEEN CODES RETURN EVEN REPLACING A DEFECTIVE VALVE..WAS A TECH TIP FROM CHRYSLER ENGINEERING..I HOPE THIS HELPS

by the alternator plugged into the egr valve.

I replaced the EGR Valve ($80 after tax), problem solved, vanruns great now. Now my problem is that I can't get the light to turn off.