I'm changing the oil do i suppose to reset the oil light or do it reset itself?
Although i have never tried this on camry, but try same procedure for timing belt replace. Set your hold down odo reset nobe, then turn ignition on while still holding it down, when display changes, release and press to match new setting
SOURCE: Reset the maintenance required light on my 2008 toyota corolla
OK ON YOUR SPEEDOMETER, THERES TRIP A, TRIP B, AND THE REGULAR ODMO... U NEED TO PUT IT ON TRIP A (WITH THE KEY OFF) ONCE U GET IN ON TRIP A, PUSH AND HOLD THE BUTTON DOWN,WHILE HOLDING BUTTON DOWN TURN KEY ON, YOU WILL SEE LINES POP UP ON THE ODOMETER, (WHERE THE MILES ARE DISPLAYED) THEY WILL GO OUT ONE BY ONE, ONCE IT STATES 0 YOU ARE GOOD TO GO.. GOOD LUCK AND THANK YOU FOR USE FIXYA.COM..KEITH..
SOURCE: Transmission oil for toyota camry 1993
1993 Camrys take regular Dexron ATF. It should be changed every 30,000 miles. If you have never changed it, and it is over 100,000 miles, I would strongly suggest a professional "transmission-flush", with a designed specifically for flushing transmissions. To just drain the fluid at this point will leave roughly 3 quarts of dirty ATF in the system; a complete flush will eliminate ny dirty ATF traces.
SOURCE: how to reset 2006 toyota sequoia after change oil
Previous Post dead wrong...
Turn ignition to "ON" position. Make sure odometer is on trip setting not on total vehicle mileage setting.
Turn ignition OFF
Push and hold odometer button while turning ignition to "ON" position. HOld for about 4-5 seconds until maintenance light goes off. Turn ignition OFF. Start up vehicle. There should be no more maintanence light.
SOURCE: Hows to reset oil light and oil filter light on 2007 nissan altmi
maintenace and oil filter. i got an oil change last month on my 2007 nissan altima and they did not reset the mileage so the lgiht on the leyboard came on and I cant fix it
SOURCE: how to change serpentine belt on 207 toyota camry
4 cylinder diagram
6 cylinder diagram
Loosen the tensioner pulley to remove the belt. It is the one that has a long bolt running through it. Once you remove the old belt, install the new one using the appropriate diagram from the above two links. Readjust the tension using the bolt you loosened to remove the old belt.
i hope this helps
matthew
107 views
Usually answered in minutes!
×