Make sure the bulb is not burned out first. If you have a voltmeter, verify voltage is present on the wire to the bulb socket. If the bulb socket is getting voltage and the bulb is proven good, then the ground wire from the bulb socket is no good.
SOURCE: 1987 toyota camry s/w back
Problem solved, Since 3 of the 4 turn signals worked I did not fuse was a problem
but after checking the turn swithch, I pulleded out the fuse which looked ok, but when
I put it back in all the turn signal lights woked! Apparently just one part of the surface
of the fuse was corroded.
SOURCE: Tail light does not work
I hope you arent letting a simple thing like a burnt bulb ruin your day??Im not sure what you have checked so far but start with replacing the bulb,check the connector very good as this has been an issue on many makes and models
SOURCE: front driver side turn signal light doesn't flash
replace flasher......usually located in fuse block area...listen in this area....select passenger side ...then select driver side...you can hear flasher clicking...you have seperate flashers for each...FLASHERS are small cubes plugged into fuse block....probable bad driverside flasher
SOURCE: Emergency Flashers totally out, Rear lights malfunctioning
Check the ground on the passenger side rear lights, it's likely bad. As for the hazards, sounds like a bad flasher or fuse.
SOURCE: tail lights work on both sides. turn signal and
check fuse to driver side turn signal lamp.check brake light bulb or replace bulb on driver side.also replace the front driver side turn signal bulb that is flashing fast.
74 views
Usually answered in minutes!
×