SOURCE: Remove rear plastic bumper cover
please email me at [email protected] with any other info or questions if you have already gone to a body shop
SOURCE: timing marks for a daewoo nubira cdx
Here is a pic if the timing marks two small marks on the cam pulleys and one small cut away on the crank pulley .
SOURCE: replacing timing belt on daewoo nubira 2000 model
Instructions
Difficulty: Moderate
Things You’ll Need:
Step1
Raise and support the vehicle
on jack stands. Remove the intake air temperature wiring, the breather
hose and intake air hose. Take off the air cleaner assembly.
Step2
Remove the right wheel. Remove the accessory belts. Remove the
crankshaft bolt and the crankshaft pulley. Remove the power steering
bolts and the timing belt covers. Temporarily install the crankshaft
bolt and turn the engine clockwise until the mark on the crankshaft
pulley, which is a triangle stamped into the crank sprocket, is aligned
with the corresponding triangular mark on the block.
Step3
Make sure that the timing marks are aligned on the camshaft sprockets.
These are a line on each sprocket that runs through a tooth on each
sprocket. These lines should line up in the middle between each
sprocket and point toward each other. If they do not line up, turn the
crankshaft one more time and they will line up. It takes two turns of
the crank to one complete revolution of the cam.
Step4
Loosen the water pump bolts; using the 3/8-inch ratchet, turn the water
pump clockwise away from the belt and loosely tighten the bolts to keep
it there. Remove the timing belt.
Make sure the timing marks are aligned and install the new belt
starting on the right side from the crank sprocket and working
counterclockwise. Keep all the belt tension on the right side away from
the tensioner.
Step5
Loosen the bolts in the water pump and rotate the water pump
counterclockwise to apply tension to the belt. Watch the tensioner,
which is above the water pump, and apply tension with the water pump
until the pointer on the tensioner lines up with the notch above it.
Lightly tighten the water-pump bolts.
Step6
Turn the engine
two more times and align the timing marks perfectly. Loosen the
water-pump bolts and, using the ratchet, apply tension to the belt
until the tensioner pointers are aligned. Tighten the water-pump bolts.
Step7
Install the timing-belt covers and the bolts in the power-steering pump
and tighten. Remove the crankshaft bolt and install the crank pulley
and the bolt, then torque the crankshaft pulley bolt to 70 foot pounds
of torque. Install all components in reverse order of removal.
SOURCE: How to Remove the Rear Bumper - BA Fairmont/Falcon
Firstly, you need to remove the rear splash shields from within the rear wheel arches and also the tail lights. Then remove the scrivets from the lover edge of the bar. Next remove the scuff plate at the boot opening and fold the carpet back. There are four nuts which hold the bar on, undo these and then lift the sides of the bar up and pull out. The bar has large clips on the side which hold it in place.
SOURCE: how to remove the rear bumper cover on a town and
From underneath the vehicle. The bumper is held on by 4 bolts and nuts. (2 on each end) Remove the nuts and bumper will pull off. Then you can pry off bumper cover to once entire bumper is off.
53 views
Usually answered in minutes!
×