It’s usually under the harmonic balancer on the end of the crankshaft. That’s the big pulley that drives the serpentine belt.
My info says lower right rear of engine block for crank sensor. Three wire connector. Wire colors, brown/orange--brown/lite blue--dark blue/dark green.
These databases are not always correct. Just my opinion.
It will be in the engine block close to the timing cover or under the timing cover.....it will have wires coming or plugged into it.....Very Fragile so do not accidently strike....The sensor has a required air gap to aquire a signal......018 air gap should be enough to work........
SOURCE: crank position sensor location
you will need to remove the starter to gain acess to the ckp sensor. once you remove the starter look on the engine block and you will see the sensor. The only problem with doing this repair yourself is that you will not be able to preform the crankshaft position variation learn procedure with out a factory scan tool. The vehicle may crank an run, but the timing advance curves will be wrong so the vehicle will probably cut off every time you remove your foot from the gas pedal. Hope this info helps!
I’m happy to assist further over the phone at https://www.6ya.com/expert/jonathan_3a3c556b4b17d1d2
SOURCE: 1997 Dodge caravan crank position sensor
it is located on the bellhousing of the transmission it gets its signal from the flywheel.look where the transmission bolts to the engine.
SOURCE: location of crank position sensor on 92 chevy corsica 3.1
You will have a no start or stalls after engine gets hot and then cools down restarts, the sensor is on the front of the engine mounted into the cam gear cover if it is not visiable get under the, (here is a picture) car and look.
SOURCE: Need to find Camshaft position sensor and crank se
CRANKSHAFT SENSOR - Under hood, center, front engine area, rear of crankshaft pulley, mounted in timing cover assembly.
CAMSHAFT SENSOR - Under hood, passenger side, upper engine area, mounted on engine in front of camshaft.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?
it is located on the right side of the motor, in the trans area. Actually in the bell housing.
355 views
Usually answered in minutes!
×