2000 dodge dakota truck blower motor resister location diagram

Marvin

• 85242 Answers
• Posted on Sep 17, 2008

SOURCE: Blower motor location for 2000 Caravan

The motor is located just under the glove box on the passenger side. I remove the glove box then the panel below the glove box. I also go ahead and pull back the carpet and the padding under the motor. It is held in place by 3-4 bolts that take a 7-8 millimeter socket. I use a swivel extension for the back bolts. The motor with the fan blade attached is a tight fit, just keep wiggling and pulling it should come out. Try to remove the old moter without cracking the fan blade, because sometimes the replacement motor doesn't come with a blade

SOURCE: 2001 kia sportage blower motor resister

Rule of thumb...unless you get a better answer:  look for a couple of wires on a small plate that is in the airflow of the fan on the heater/ac unit.  The resistor pack is always air cooled by the fan.

SOURCE: air conditioner blower motor resister on dodge grand caravan

in my 2004 grand caravan it's behind the glove box and left of the blower motor. disconnect the wires first then remove the 2 screws to pull out the resistor unit. First make sure you have removed the negative of your batterie. I had the same pm that prevented the blower motor to operate in any speed. I hope this will help

SOURCE: location of the thermostat on a 2000 dodge dakota 3.9l v6 located

right in front on top of motor follow your top rattior hose to the motor

Jeffrey Turcotte

• 8991 Answers
• Posted on Sep 23, 2010

SOURCE: diagram for the placement of

From autozone.com
2003-04 Vehicles

CAUTION On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in an accidental airbag deployment, possible personal injury or death.

NOTE The blower motor is located on the passenger side of the vehicle under the instrument panel. The blower motor can be removed from the vehicle without having to remove the HVAC housing.

1. Disconnect and isolate the battery negative cable.
2. Disconnect the wire harness connector from the blower motor.
3. Remove the three screws that secure the blower motor to the HVAC housing.
4. Remove the blower motor from the HVAC housing by rotating and tilting the blower motor as needed for clearance.
   

Fig. View of the resistor block screws (1), blower motor resistor (2), resistor block wire connector (3), blower motor screw (4), blower motor (5), blower motor wire connector (6), blower motor screw (7), HVAC housing (8), wire harness retainer (9), blower motor screw (10)

To install:

1. Align and install the blower motor into the HVAC housing.
2. Install the three screws that secure the blower motor to the HVAC housing. Tighten the screws to 20 inch lbs. (2.2 Nm).
3. Connect the wire harness connector to the blower motor.
4. Reconnect the battery negative cable.