I have a 2004 Suburban and the air bag light came on. It was one of the sensors located on the inside of the front bumper. They were cheap enough, I replaced both. Take the big plastic undercover off, and look on the inside of the front bumper, on the bottom, you will find them. A 10mm socket on a 1/4 drive reached them easily. Un hook the electrical connection, unbolt, and bolt on the new ones. Then reattach the electrical clip. Here is a video https://www.youtube.com/watch?v=UlcHQ-jmm0E
SOURCE: Airbag light goes on and stays on, where is the
doubt very seriously that it is a fuse problem.....does the horn blow steady as you turn the wheel.... they have a problem with the the rotary contact assy. being intyermittent... sometimes the horn has drop outs when turning wheel... also the air bag diagnostic module looses contact with the driver airbag... causing light to turn on..need to scan before you put much money in.. but fuse not the problem
SOURCE: 2005 Suburban airbag light is on. What do i need
One thing you can check, and that is to look under the driver and passenger front seats, there should be a few wires and connections, check that these connections are good, sometimes things like bottles etc that have been put on the floor can roll under the seat and disturb the connections or passengers in the rear can accidently kick the installation.
hope this helps
SOURCE: I changed the battery in my 2005 chevy suburban
Disconnect red battery cable from post then re-attach.
SOURCE: 2005 Suburban: how do you chang headlight bulb on 2005 chevy subu...
first see if you can reach behind the whole light and get to the connector, daytime running light is more towards the centre of the truck. if you can reach it, just turn it and pull the bulb out. if not then its either going to be bolts or long rods holding the light in place, remove those and then turn the connectors to expose the bulbs
SOURCE: Our service airbag light came
Hello and welcome. this light comes on to warn you that there is a problem with the air bag system. when this light comes on, the air bag control module will store a trouble code, this code is used to help isolate the problem. what you will need to do first, is have the air bag system scanned for trouble codes. then a repair can be made on the system
1,045 views
Usually answered in minutes!
×