Candice ck this out...
https://www.youtube.com/watch?v=ZF7UNFXxugA
2008 malibu..
https://www.youtube.com/watch?v=rrBKPADyQvs
Best to you.
I realize what I say is going to be 5 years old but the dealer has to view your title and vin so they can cut a key.
SOURCE: program second key fob
Your key can only be programed at the dealer. They have to use a scan tool and a unique id code that they get from the factory. It is done this way to help insure that the vehicle is less likely to be stolden.
SOURCE: How do you program a key fob for a 97 chevy
There are two wires in the trunk that you have to fumble around with. When you open the trunk it is on the right hand side...They may be taped up, play around with the two wires until you here the locks of the doors lock and then unlock and the trunk latch will open. Make sure the windows are open when you try this so you wont get locked out by chance. Once this happens, hold the "Lock" and "Unlock" buttons simultaneously for 15 secs until the locks repeat the locking and unlocking pattern they performed earlier. Once this happens, you are programmed and ready to go.
Testimonial: "Thanks!"
SOURCE: 2008 chevy malibu. how to program keyless entry remote
You must take it to the Chevy dealer.
Testimonial: "thank you"
SOURCE: How do u program a new key fob for a 2004 chevy
Close all the vehicle doors.
Insert the ignition key into the ignition lock cylinder.
Press and hold the DOOR unlock switch.
While holding the DOOR lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
Release the DOOR unlock switch. The doors will lock and unlock to confirm the program mode.
Press and hold the LOCK button and the UNLOCK button simultaneously on one keyless remote. After a delay of approximately 15 seconds , the doors will lock and unlock to confirm the programming of that transmitter.
Repeat the previous step to program up to four transmitters.
Turn the ignition switch to the RUN (one more click forward) position in order to exit the keyless entry transmitter mode.
Operate the transmitter functions in order to verify correct system operation
SOURCE: I changed my car battery, now my 2008 Nissan Altima key fob won't work
There is a special procedure involved in keying your fob to your car once the battery has been changed. You must lock and open the door with your key. Turn the ignition to "on"(not start) then push the fob's open and close button, then shut off ignition. This procedure is done everything the key battery is changed. Hope this can help you!
------------
Motorcycle Diagnostic Scanner
How to Program a Key FOB for the Chevy ... your Chevy, if you obtain new or replacement keys they will need programming to work with ... How Do I Program MyKey Fob? ...
239 views
Usually answered in minutes!
×