All the knowledge you need to fix the problem is in service and repair which will help you to locate the problem with diagram and you will get the manual from the given link https://toolsnyou.com
SOURCE: where is throttle position sensor located on 2000 honda passport
Normally attached at opposite end of throttle linkage. Remove your air cleaner intake hose at throttle body, and observe throttle plate that opens & closes as you press accelerator, it will be at the end of that, on outside of housing.
SOURCE: 2000 Honda Passport wont start.
I ended up finding a repair shop here in Cleveland. The problem ended up being a short in the electrical system. My fuse kept blowing. That's why it wouldn't restart. If you decide to take your vehicle to a repair shop, have them check out the electrical system. My problem was found under the drivers side fender. Some of the wires were corroded. Good luck!
SOURCE: 2000 HOnda Passport with rough idle,
you can use propane to find a vacuum leak take a bottle and put a rubber hose on it so you can direct it in specific spots and just let a little gas flow if you find a vacuum leak it will bring the RPM of the motor up slightly do not light the torch just let the gas come out
SOURCE: Vacuum Leak on a 2000 Honda passport
Replace upper intake gaskets. They are made of metal and plastic. A common problem. Do not remove the very top plenum cover gasket.
SOURCE: evaporative emissions leak for 2000 honda Passport
if small leak indicated it is most likely a gas cap
75 views
Usually answered in minutes!
×