SOURCE: how do you change the right front headlight bulb on a kia sedona
Remove the headlight assembly. Just remove the 3 bolts with a 10 mm socket and pull it out so you can disconect the wire harness. After that pull the whole assembly out and unscrew the bulb cover. The bulb is held in with a spring clip.
SOURCE: how do i change the spark plugs on 2003 kia sedona van
Hey bobnatboys,
The back 3 spark plugs are a pain to get to.
But I have 2 methods, which perhaps you can put 2 an 2 together to make it easier for yourself.
firstly make sure you buy new ignition leads because they can break when removing them from the spark plugs. The front (cylinders 1, 3, 5) are easy to get to with 3/8" drive sparl plug socket, an extension bar and ratchet. As for the back 3, put the vehicle up on stands at the front, grab the spark plug socket, a short extension bar and the rachet, crawl underneath the front of the car on your back and start swearing. 2 hands are required. First off, remove the plug leads by a small twist then pull. This is where the plug lead might break. Once the ignition leads are out of the way (yes, even though they seem to come up hard against the firewall - by manipulating them they can be removed), drop the plug socket down the hole onto the spark plug, feed the short extension bar into the hole and click it onto the socket, then feed the ratchet up to the extension bar (2 hands) and proceed to loosen/undo the spark plug. If you don't have the socket with the rubber piece in the end of it - to grip onto the plug, then you will need a thin magnet to drag them out with. Reverse the process for installation.
Now the second option is remove the inlet manifold, its an easy procedure, and no need to hoist the car, just remember once the inlet manifold is off, block the holes to prevent things from falling in.
SOURCE: Is the catalytic converter on my 2003 Kia Sedona
i dont know if it is but the cost to replace it shouldnt be more than 300$
SOURCE: kia sedona outside door handle replacement
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to get to remove the bolts securing the outer handle on
SOURCE: how to remove the rear bumper on a 2005 Kia Sedona
1. Remove rear combination light assembly. A. Remove two mounting screws. B. Disconnect electrical connector from rear side of light assembly. 2. Remove bumper assembly. A. Remove four fasteners and four retaining screws from top of bumper assembly. B. Remove mud flap from bumper assembly. C. Remove two screws from bottom of bumper assembly. D. Remove two screws from side of bumper assembly. E. Remove four bumper mounting bolts from under of vehicle. 3. Install rear bumper in reverse order of removal.
112 views
Usually answered in minutes!
×