Most all relays are located in the fuse box under the hood
SOURCE: remove car stereo in a 2009 jeep patriot
Turn the key on applie E-brake move the shifter to the lowest postion to be able to remove the center bezel. with a small plastic pry tool pry the gray bezel out. Caution use caution don't pull the bezel out all the way u can break the A/C control lines. turn the bezel to the side so you can remove the radio. 4 philips head srew hold the radio in. remove the radio and disconnect electral connecter. hope this helps..
SOURCE: amateur radio installation in 2009 jeep patriot
To run any wire through the firewall, find a spot that is both reachable and unobstructed on both sides of the wall. I generally use a very short bit so after penetrating, it does not accidentally plunge into other wiring or components, or I use a collar over the bit (a small piece of tubing, leaving only 1/4" of bit exposed) I sometimes also "cheat" by poking a hole in the rubber boot where the steering column goes through.
Whenever passing a wire through sheet metal you must install a grommet. (if none are available, you can make one by using a piece of rubber tubing or the cut off end of an old tire valve.)
When tapping power from the battery, you will need to use a relay and switch attached to the "accessory on" side of the ignition switch, to prevent whatever you are installing from remaining on after the vehicle has been turned off. Use fuses in all new power sources as well to protect the vehicle and your new install from damage.
In creating a new circuit, you have the opportunity to use shielded wire, which will prevent stray electrical "noise" in your set" not a bad idea to do that.
good luck
SOURCE: Hi How do I reset the
Most if not all scan tools have an option to clear or reset codes without the use of any tools or touching the battery. Consult your tool's manual for information on how to do it with your particular model. If you want to try the fee way ,, unhook the battery , turn on the headlight switch for 10 minutes, then reconnect your battery , the codes should have cleared , if not you have to h ave them cleared with the scan tool
SOURCE: 2009 jeep patriot, my esp,
What did the dealer tell you the problem was?
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
SOURCE: drive belt jeep patriot 2009,
Go to this site and go through the menu of your vehicle to the last page and there look for a link to "Routing" that will be a picture of your belt's routing around the pulleys. Dayco hope this helps FixYa up.
1,223 views
Usually answered in minutes!
×