Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything
someone on fixya recommended it to me and I thank him even today
They have full manuals and it's verrrrry cheap and mine
I got free in offers
3rd time I also had an issue with
the file so the girl replaced it in 30 mins
there is one more but i don't remember its name it was 2 years back bitman something link this
Try it out brother
SOURCE: kia sedona 2002 error code P0118
P0118- (ETC) Engine Coolant Tempature sending unit, high input. Your ETC is either faulty or has a poor wiring problem. Thank you for using fixya.com
SOURCE: changng antifreeze on a kia sedona
there is no drain plug you will have to take the hose off the bottom to drain it then turn the engine over for just a few seconds then turn it off , this will pump out any other fluid
SOURCE: drivers front seat latch doesn't work 2001 beetle
its the cable from the handle to the seat mechanism that locks the seat in place. an easy fix with new cable from vw .i think its a dealer only part !
SOURCE: locked my keys in trunk of 2002 kia rio
Two large bolts secure the bench in place. Remove them. Three large bolts sechur the backrest in place. Remove them. Lift the backrest up until it unhooks from the three supports near the top. You will the be able to remove the plastic panels leading to the trunk. They are secured with small plastic retainers. Good luck. Takes about 15 minutes.
SOURCE: TAKE OUT REAR SEAT ON 2002 JAGUAR X TYPE")
I had the same issue today with a 2004 jag.
1. Once I had the locksmith open the door. We proceeded to remove the back seat. Not an easy task, but this is the only way.
A. remove the plastic kick plate on floor leading to back seat. This will allow you to pull out the padded liner that is not part of the seat but cushions each side. It will not completely come out, but expose a star nut that must be turned loose with six more later on.
b. The front of the back seat is held down by two copper u shaped wires, that must be popped up and out of a white piece of plastic, Once this is done you can lift up the seat portion and remove it from the car. You will now see six star bolts that must be removed. After you take them out the round bar holding the upper portion of the seat can be removed or popped out enough so that you can seperate or spread the back portion of the seat from each other in sections. Once this is done you will be able to pull out a section far enough out to gain access to the trunk.
It takes about 15 minutes once you understand what your doing, and about an hour if you have never done it. The trick is allowing the lock smith to open the car. The alarm will sound off for about 2 minutes then stop. Unless you have the rear center console removalbe panel and arm rest, then the only course is exactly what I did, removing the back seat. They charged me 150.00 dollars with me doing most of the work. Not much I could say, as I was the *** that locked my keys in the trunk. Best bet for a Jag is to carry another key with electronic trunk opener mounted underneath the car in a key lock box. Well worth the investment, as most people end up getting their car towed.
It is poor feature on a Jag that the only way you can get in a locked trunk is through the back seat, but this is how it is done.
Believe me, it is the only way other than having it towed to the Jag dealer so he can figure out. Thier is a way to jump a wire under the passenger side dash, but you may end up shorting out the whole electrical system, I dont think it is worth the risk, unless the person doing it, has previous experince. Hope this helps, and happy tearing out your back seat. You can do it, the first time is always a little tough.
Dsaldo vermont
47 views
Usually answered in minutes!
×