Mazda 1998 b2600 how to check auto oil - Mazda Cars & Trucks

SOURCE: 1992 mazda B2600 ute

find the oil pressure sensor on the block and unplug it the light should go out, if not try grounding it if it goes out make sure you have adequate oil pressure and change the sensor please rate -jeff

SOURCE: Have Mazda bravo B2600 4WD ,has white smoke &

You dont say weather its a petrol or diesel engine as there a slight differance in the answer and if a turbo on a diesel thats even more of a differance, but taking it a petrol .
Well to start with the white smoke Isent smoke its water and after going through the engine it turns into Steam and thats what you see..
Running on 3 clyinders is caused through 1 cylinder isent working as a engine should and has a bad valve or a broken piston ring or more and even a cracked head and gasket letting the water through,,,also the broken ring works like a oil pump as if not firing given you power then it works like a oil pump and pumps it into the cylinder that dosent work only pumping oil into the hot exhaust system while running.CAUSING SMOKE
And if a turbo then could be the turbo bearings worn and pushing oil into the engine and still doing the same as before.
Let me know how you get on. RON

SOURCE: i need to set up the camshaft timing marks on a 1994 mazda b2600

its not just the camshaft timing marks you set up, you also have to have the crankshaft timing mark set right to or you may damage your engine
check the internet for the right timing procedure for you model car ok

SOURCE: 1998 mazda bravo ute b2600 petrol- Cannot locate

No!!!! The motor has oil filter.Look from the top of the motor.It is right there.Under the manifold.Hope this helps

SOURCE: when replacing gearbox oil in a mazda bravo b2600

should be rt on the rear diff cover and fill up until fluid starts coming outta fill hole