You can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
SOURCE: LOCATION OF FLASHER UNIT 1993 LN130 HILUX 4RUNNER AUSTRALIA
You found this long ago I'm shure, but just in case. Flasher mounts on dash suport-bar way up behind the gauge cluster. Check out this site www.toyodiy.com It rocks lots of info.
SOURCE: my toyota tazz (conquest) has a major oil leak. I
you need to replace your top gasket i had the same problem with my tazz the car decided to start over heating and used alot of water so take it away and have it fixed before your problem becomes bigger and i payed R1000 to have my car fixed properly
SOURCE: Toyota tazz 130 (2001 model) is leaking oil from
check where the oil leak is exactly coming. possibly the leak is only from the oil drain plug that needs a new washer. if the leak is coming from the edge of the oil pan itself then you need to remove the oil pan itself, thoroughly clean the oil pan before installing put a silicon on the edge and bolt it back but ensure to tighten the bolts evenly.
SOURCE: MY TOYOTA TAZZ 2005 130 FUEL GAUGE IS NOT WORKING
Is your temperature gauge also faulty? I've read that it could be the voltage regulator in the instrument cluster. Can't confirm.
SOURCE: I have a toyota tazz
You really need to find out what your oil pressure is. I would connect a manual gauge to get readings...we don't want to take any chances when it comes to oil pressure. If your oil pressure is ok, then most likely the oil sending unit is faulty and will need to be replaced. I hope this helps.
951 views
Usually answered in minutes!
×