SOURCE: AC works, Heater not working, 2003 Hyundai Accent.
Check the coolant level, do this with a cold engine. Or if you have recently used it. let it cool down for about 25 minutes before removing the radiator cap. if it is low, refill with coolant. If it does not, check your thermostat. Or better yet replace your thermostat. Be sure to get the right one . the same degrees as your old one. Just ask the teller to give you one for your engine size and car Model.And year.See where the radiator cap is. Then drain some coolant to where it will not spill from the radiator cap. Remove the hose nearest the radiator cap and you will get to the thermostat housing. Remove the housing and note how the thermostat is placed. Take of the thermostat housing and the old thermostat. Clean the housing and around the hole where the thermostat goes of any deposits. Get some grease and cover the new gasket with grease on the housing to hold it in place. replace the New thermostat and make sure it is flush with the engine and the housing. If it is off , you could break the housing upon tightening the housing.replace the hose and refill with coolant slowly to eliminate any air spaces.. Also check the coolant reservoir and fill it to the indicator line. Restart the car and chek for any leaks. Then check the heater after the engine heats up. If that does not do the job it could be the temperature sensor or the heater core.The heater core will take more time to check and clean or replace.
SOURCE: replacing exterior door handle 2003 hyundai accent?
remove door panel which is attached by screws,peel away plastic liner and look inside door at back of door handle..using needle nose pliers pop off the small steel rods that are for inside door mechanism,then remove the one bolt that attaches the handle to the inside of door and from outside of door remove handle.Replace in reverse order!
SOURCE: How do I disassemble the [center]dash to replace
remove all the screws
there are 2 in center console at side 2 in ash tray and 2 others usually look arround pull gentley and locate all screws
SOURCE: Central locking on my Hyundai Accent no longer works
u will have to replace the celenoid so it can work normally again or just remove the celenoid and the car wont have a shift lock any more, you can also bypass the lock by pressing on the small hole on the top left side of the shifter.. hope this helps ..
SOURCE: Antifreeze for a 2003 Hyundai Accent
hi as this vehicle takes 6.5ltrs of liquid in the cooling system ( 1.6 16v based on ) as you did not give the engine size, but, 3.5ltrs of coolant is needed as it should be 50/50 depending on where you are and the temperature it has to deal with, warmer countries only need 30/70 That's 30 coolant to 70 water, but, if you are in a colder country it would be 80/20 that's 80 coolant to 20 water...and any standard coolant is ok no need for a specific one hope this helps please vote thanks
http://schematicsdiagram.blogspot.in/2012/03/this-is-how-system-operates.html
This will help.
Thanks.
62 views
Usually answered in minutes!
×