SOURCE: Engine 1996 Ford Ranger
the transmission dipstick on the 4.0L at least is near the back of the engive over to the left it should say transmission fluid on it
SOURCE: 1987 Ford Ranger stuck in 4 wheel drive!!
Chances are the linkage for the transfer case is out of adjustment try loosening the adjuster bolt and put the 4WD shifter into the position 4WD high or low (depending upon which position it's lockup in) then lock down the adjuster bolt, try to shift out of 4wd sometimes you need to go forward and backward with the vehicle to get it out of 4wd, when you get it out of 4wd you may have to fine tune the adjustment to get it to engage and disengage smoothly it's a trial and error thing keep resetting adjuster until you get the desired effect.
SOURCE: How do you remove the gear shift lever on a 93 ford ranger?
many of these trucks have a mazda trans in them, to remove these shifters you will need to remove the 4 phillips head screws from the corners of the trim around the shifter boot and pull it up out of your way. it's not necessary to remove the boot from the shifter, just lift it up for access to the top of the trans. at the base of the shifter on the top of the trans you will see a plate attached with torx head screws. remove all but 2 of them, now make sure the trans is in neutral and remove the last 2 screws and pull the shifter straight up. the shifter is now out leaving a big hole open on the top of the trans for dirt to fal into so put a wrag in it or screw a piece of cardboard to it. installation is the reverse. good luck
SOURCE: how take off pins not bolts on caliper 87 Ford Ranger front brake
The pins / wedges just tap out use a scewdriver on the metal edge of the pin just tap it out to the rear and when putting them back in just tap them back in from the front. You will see they are diamond shape and metal cased around rubber very easy to do just take your time.
SOURCE: i replaced my auto transmission with overdrive in
switch to a manuel transmission...
The ford A4LD transmissions are one of the worst transmissions ever manufactured...
When you did the swap , did you flush the lines and use a rebilt torque converter?
148 views
Usually answered in minutes!
×