What should the PSI be for the fuel pump for 04 durango 4.7 ?

best bet is to go buy a repair manual if your going to do that kind of work you'll need it

Between 55 and 63 psi with ignition in on position and fuel pump energized not less than 45 psi upon 5 minute bleed down with pump not energized.

You Might have a bad fuel pump.

The FIRST thing to do is scan your onboard computer network for possible fault codes. You may just have a code for a cranshaft position sensor or Mass Air Flow sensor or something similar that will explain why the engine is not getting any fuel.

Check the fuel delivery system to make sure it is performing according to manufacturers specifications:

The fuel pressure specification for 1999 Dodge Durango is 44-54 Psi. (3.0-3.8 kg/sq.cm) Please note that the specification published by the manufacturer is with the key ON, engine OFF and the fuel pump being activated with a scan tool.

Also note that "CLOSE" is not good enough. I have had vehicles towed in that were only 2 or 3 Psi under the minimum specification that would not start.

If the fuel pressure/fuel delivery is within specifications, then you need to check your fuel injection system. If it gets this far, let me know and we can continue diagnosis.

Sounds like a weak fuel pump.Check your fuel pressure and if its within specs then replace fuel pump and fuel filter.I think it should be 44-54 psi.Get a repair manual to make sure you have the right specs.

Sounds like it maybe a weak fuel pump,so i would check the pressure it should be 48-52 psi

Hi
Pressure is 49.2 PSI Volume is 1/4 of liter in 7 seconds. Let me know if you need more help.
Thanks
Jason

auto choke problem ,try changing the temperature sensor

49 to 55 psi

What ever the fuse controls has the problem and needs to be addressed first then replace the fuse. Example; if the fuel pump was shorted to ground every time you put in a fuse, the fuse will blow so the fuel pump circuit would have to be take care of first.