SOURCE: 2001 Kia Rio Engine Cranks, Won't Fire, Reoccuring
i am having the same problem, thought it was ful pump, no go, I heard they had problms with the fuse box and wiring harness, my mechanic messed with mine a few days ago and it has not did it since, but I am looking at changing that. GL
SOURCE: kia rio 2002 camshaft pos. sensor just replace still light check
check the belt,if its out it will flag up this code,your car will run on sequential firing from the crankshaft sensor,failing that put an oscilloscope on the signal wire at the sensor and ecu its possible the ecu might not be seeing the signal,start with the basics first
SOURCE: 2001 kia rio fuel pump does not work
Are you positive its the fuel pump? Have you tried running the pump with the return line off to see if it pumps fuel? They don't always have to make a noise.
Also refer to www.kiatech.info
SOURCE: crank sensor 2001 kia rio
On 2001-2005 vehicles the crankshaft sensor is mounted on the front of
the transmission case adjacent to the flywheel.
Please rate and god bless:)
SOURCE: knock sensor replacement
Turn ignition off. Disconnect knock sensor 3
-
pin harness connector. Locate knock sensor, on cyli
nder block.
On Optima 2.7L engine, sensors are located on both
sides of cylinder block. . Remove knock
sensor from cylinder block. To install, reverse rem
oval procedure.
86 views
Usually answered in minutes!
Did it start before you fitted crank sensor
×