Question about Ford Fusion

1 Answer

I am hooking up new headlights on my sisters 2011 fusion hybrid. It has LED's, so I need to know which wires on the driving lights, not the fog lights, which wires are positive and negative.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 630 Answers

If you have test light connect the light to good ground and test both wires the one that light the bulb is positive. If you don’t have one usually the lighter wire is ground then dark is positive hope that help fast to assist you. God bless

Posted on Jan 13, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 840 Answers

SOURCE: 2004 Maxima driving / fog light bulb replacement

if they are near the bottom of the bumper the only way is take the lower shield off and drop the lt and rt splash shields

Posted on Jan 25, 2009

co7196
  • 3433 Answers

SOURCE: fog lights not turning on

Sounds good to me except, the switch light shout be on the relay primary circiut and light off until you turn it on. When you turn the switch on, it lights up and energizes the relay, the relay closes and completes the secondary circiut for ythe fog lights. VIOLA' I have a silverado. done deal thanks

Posted on May 28, 2009

  • 1 Answer

SOURCE: 2001 VW Beetle Headlights, turnsignals and fog

four digits in your question

Posted on Apr 17, 2010

  • 1 Answer

SOURCE: Wiring diagram to install OEM 2010 Toyota Camry fog lghts

here is a link that can help you.
http://www.donmar.com/Tech/FogLight-TCA-303.pdf

Posted on Dec 26, 2010

sscullys
  • 984 Answers

SOURCE: I need the wiring diagram

This is the diagram for the fog lamps ( headlamp is a different cell ).
If you are trying to add them to the existing wiring, do not expect the headlamp switch to cab fuse panel wiring to be there ( that is usually what is missing when you can find the fog lamp connectors under the front of the truck ).

File Save as so you can magnify it with the JPEG viewer you use.

sscullys_90.jpg

Close up of switch
sscullys_91.jpg

Posted on Jan 28, 2011

Testimonial: "Thanks for the diagram, I'll have a pro install the needed wiring."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

HOW DO YOU INSTALL THE DAYTIME DRIVING LIGHTS OR THE FOG LAMPS ON THE FORD FUSION 2007


New car day running light is achive only by ecm programming

Ask the dealer

Apr 12, 2014 | Ford Cars & Trucks

1 Answer

Windshield washer clogged on 2011 Ford Fusion Hybrid


Have you tried pole a piece of wire like off a wire brush into the hole? I know it sounds silly, but most times what clogs the outlets is wax when you wax the car.

Dec 07, 2013 | 2011 Ford Fusion Hybrid

1 Answer

I have toyota 2011 RAV4.and want to know how to install fog lamps and new wireing


This is a social web site,not an automotive
repair shop or tech line, with access to free info

On the fog lamp assy,I would crawl under a similar
vehicle & see if all you need to do is remove a cover
plate or drill some holes

On the wiring,I think the dealer parts dept will provide
some harness, that should plug in somewhere on yours

May 24, 2012 | 2011 Toyota RAV4

1 Answer

I just bought a 2009 dodge ram without fog lights i bought a bumper with fog light an switch them out but i need to know how to connect the lights to the factory switch inside what do i need to do


If your PU didn't come with factory installed fog lights then you will need to replace your headlight switch with a fog light enabled headlight switch.

Here is a link to the factory dealer-installed instructions.....

http://www.mopardodge.com/accessories/Instructions/82208102AC_IFU.pdf

You only need to get the components you don't already have. The headlight switch that is fog enabled will pull out for fog light operation, if yous doesn't you need to replace the switch and do some wiring as shown in the pdf file linked above.

Hope this helps!

Mike

Apr 18, 2011 | Dodge Ram 1500 Cars & Trucks

1 Answer

2010 Ford Fusion - After changing the oil, how do I extinguish the oil change warning?


You use the "Setup" and "Reset" buttons in the Information Center. The sequence of button-pushing is different for Hybrid and Non-Hybrid vehicles. The sequence for your car should be outlined in your Owner's Manual.

Dec 07, 2010 | 2011 Ford Fusion

1 Answer

I have a 2008 Ford Fusion and the passenger side head lamp will not come on. The fog lights and driver side head lamp works but the passenger side will not work on bright or on dim, what could this be?


Hi. Since the headlight on the driver side is working then we dont have any problem with the fuse or relay. Check the wiring and the socket of the passenger headlight if it is intact to the bulb. If it is intact, then this could be a headlight problem. Time to replace the passenger headlight.

Sep 06, 2010 | 2008 Ford Fusion

1 Answer

I have a 2000 Camaro. My problem is front turn signal/fog light related. First...my fog lights don't come on at all. No biggie but mentioning it due to my second part. With my headlights manually on...


You can replace the parking light/turn signal bulb with LED lights. The LED draw next to nothing in AMPS and produce no heat at all and last for ever. You can pick up the replacement LED lights for your Camaro at most Auto Parts store like Auto Zone or Pep Boys. Good luck and keep me posted for any more questions you may have, I'm running the LED lights on my wife's Montana for that same reason.

Nov 17, 2009 | 2000 Chevrolet Impala

2 Answers

Lights seem ultra dim


yes. it could be a poor ground. If you are handy you can check this out yourself, otherwise go to any autoelectric shop where the technician will solve this for you.

Oct 10, 2009 | 1995 Ford Mustang

1 Answer

Drivers side reverse light on while i drive.


Your car has rear fog lights. The rear light that you see come on with your headlights is your rear fog light. The light in your dash is the rear fog light indicator. To turn off your rear fog lghts push your headlight switch in half way. To turn off your front fog lights push in all of the way.

Jan 13, 2009 | 1999 BMW 328 Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...