Question about Dodge Caliber

1 Answer

Is there some kinda trick to putting the dam radiator plug back in a 07 dodge caliber it dont wanna go back in

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Welcome Back:

    Visited the website for 2 consecutive days.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 6 Answers

Push it in hard as u can then turn to tighten
..it should screw in and has threads on it

Posted on Jan 13, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 412 Answers

SOURCE: Needing to locate the airbag control module '07 caliber

it is located behind the floor shifter in center console..under small piece of carpet

Posted on Jun 20, 2009

  • 1 Answer

SOURCE: need instuctions to change tail/break lights on 07 dodge caliber

popohead, if people thought it was easy, they wouldn't be here asking. Your reply is useless.

To remove the pins, look a them closely. Notice that there's two little notches cut into the cup that holds the pin. Use a flathead on each side to leveredge them out a little. If that doesn't work at all, you can use a pair of pliers to firmly grip the head of the pin and pull straight out. Quick firm pull.

Once the first pin comes out, the second pin should easily come out. At that point, firmly grip your taillight housing, and pull straight back: Don't try to wiggle it out, and don't try to lift it to one side or the other like a trunk or door. Just pull it firmly straight back like you would a dresser drawer.

Once it's out, the little wiring harnesses come out of the taillight housing with about a 1/4 turn, and the bulbs just slide straight out of those.

Good luck!

Posted on Nov 01, 2009

cmcduncand
  • 714 Answers

SOURCE: 07 Dodge Caliber alternator

$270.00 to $300.00

Posted on Feb 12, 2010

  • 12 Answers

SOURCE: how do i install a alternator for a 07 dodge

you will need to disconnect the negative battery cable at the battery, remove right front wheel, remove underbody air dam, remove accessory drive splash shield, remove the accessory drive idler pulley. Next loosen the lower mounting bolt, then loosen the a/c compressor and relocate(pull down and to the outboard side of the vehicle to make room for the alternator the come out) next uplug field circuit from alternator and the B+ terminal nut and wire. remove upper mounting bolt on the alternator and lower mounting bolt. relocate the terminal to the other side of the a/c line. Rotate alternator pulley down and slide down and out of vehicle. Yes, its a pain in the ****.

Posted on Mar 11, 2010

roniecon
  • 6927 Answers

SOURCE: where is the radiator fan relay for a 07 dodge

Not sure,but look on drivers side below radiator.

Posted on Jul 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dodge caliber 07.today i put 2 jugs of water in it an hour parked cut car off opened radiator cap steamed and water so sprayed slightly alot of steam.now only cranks but won't turn over completely.


You cannot put plain water in a radiator because it does not conduct heat like antifreeze coolant does. IT boils over fast, which you found out the hard way. The question is where is that water going? Chances are you have a head gasket leak and now water is in the cylinders and they wont fire because the spark plugs are wet.

Mar 09, 2016 | Dodge Cars & Trucks

1 Answer

07 dodge caliber throttle control


Usually replacing the TPS - throttle position sensor will get rid of this issue.

Mar 31, 2014 | 2007 Dodge Caliber SXT Sport Hatchback

1 Answer

07 Dodge Caliber, ETC light


Try replacing the TPS first, then if your light doesn't go off, take it to the dealer.

Mar 31, 2014 | 2007 Dodge Caliber SXT Sport Hatchback

1 Answer

Can't close plastic drain plug on dodge caliber radiator


There may be dirt blocking it. Let it rinse out for a while, check the looks of the fluid. Wiggle the plug while it drains. You may not have to remove it completely to drain.

Dec 02, 2013 | 2008 Dodge Caliber

1 Answer

CHILL ZONE IN DODGE CALIBER NOT WORKING


There is a vent on the roof of the chill zone that allows a portion of the a/c to circulate in that compartment, keeping it cool....as long as the a/c is on...and the vent is open :-)

It's okay, I've had my 07 caliber since 07 and just now noticed that myself....hey is your dome light a flashlight?

Jun 08, 2012 | 2007 Dodge Caliber SXT Sport Hatchback

1 Answer

Cannot remove lower ball joint from 07 dodge caliber


if it has no bols it press in go to auto part store they rent you the tool you need get all your money back for rent

May 19, 2011 | 2007 Dodge Caliber SXT Sport Hatchback

1 Answer

Where is the radiator fan relay for a 07 dodge caliber loacted?


Not sure,but look on drivers side below radiator.

Jul 05, 2010 | 2008 Dodge Caliber

2 Answers

How do i install a alternator for a 07 dodge caliber sxt. what tools would i need to remove and install.


you will need to disconnect the negative battery cable at the battery, remove right front wheel, remove underbody air dam, remove accessory drive splash shield, remove the accessory drive idler pulley. Next loosen the lower mounting bolt, then loosen the a/c compressor and relocate(pull down and to the outboard side of the vehicle to make room for the alternator the come out) next uplug field circuit from alternator and the B+ terminal nut and wire. remove upper mounting bolt on the alternator and lower mounting bolt. relocate the terminal to the other side of the a/c line. Rotate alternator pulley down and slide down and out of vehicle. Yes, its a pain in the ****.

Oct 14, 2009 | 2007 Dodge Caliber SXT Sport Hatchback

1 Answer

My 2007 caliber runs hot on freeway or climbing hills.i have changed oil new thermostat.coolant at correct level no leaks from coolant lines help


check fans are working properly. check radiator for clogs. you might wanna check catalytic converter although its a 2007 you might wanna check them anyways.

Aug 24, 2009 | Dodge Caliber Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

83843 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...