SOURCE: 99 GMC sonoma will start with starting fluid then
Will the engine start on its own after the engine is warmed up?
Let me know.
Regards,
SOURCE: window on drivers side wont go up or down but
Ours did this, too. We just had to wait for everything to reset (a few minutes) then it worked fine.
SOURCE: The heater still won't work after I changed the thermostat on my
heater blows cold air everything else works fine 1999 gmc sonoma
SOURCE: How do you replace the rear u joint on a 99' gmc
Mark the driveshaft and yoke in a manner that will allow you to reassemble it in the same orientation that it's in now. This is done to avoid driveline vibrations. Next remove the 4 7/16" head bolts on the driveshaft yoke. Use a lone screw driver or pry bar to pop the driveshaft off the yoke and slide the other end out of the transmission. Using a u-joint tool press out the old u-joint and press in the new one. You could bring this to a machine shop or a mechanic and have them do it for you if you don't have the correct tools. I think autozone may rent a ball joint press out for free. Next reassemble it orientated the same way you took it off.
SOURCE: How much, and what kind of oil do you put into a
5w30 is the normal oil viscosity that GM recommends on most all of there vehicle from that era.
The four cylinder will hold about 4.25 quarts and the V-6 maybe a tad more. Like I tell all of hour new guys they take as much as needed to read full on the dipstick. If you're changing oil have five quarts ready and you have a little left over for topping off.
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
216 views
Usually answered in minutes!
×