The key will not turn in the ignition of my 2008 hyundai Vera cruise help

check for the button called child locks first?

If you have trouble in fixing your vehicles, tryhttps://big-manuals.com/products/hyundai-vera-cruz-service-repair-manual-2007-2009 . Very helpful

1. How to Remove and Replace an Ignition Lock Cylinder ...

   ? 5:13
   www.youtube.com/watch?v=S9I4MnRIrHk
   
   Sep 2, 2012 - Uploaded by RatchetsAnd Wrenches
   looking to take out ignition switch on a 1973 Porsche 914 ... key from a Hyundai Tucson 2008 .... the key was cold and broke in the ignition ... Going to try to change out my 2008 sonata using this as a guide. wish me luck.

There's nothing in the manuals about special tools. I have the same problem. I think you'll have to remove the lower bumper in order to get good access to it. It appears that there is a black housing screwed into the bumper from the rear side and the lens would snap into that.

Removal & Installation

Specific to:
Hyundai Entourage 2007-2008

1. Before servicing the vehicle, refer to the Precautions Section.
2. Disconnect the negative (-) battery terminal.
3. Remove the crash pad lower panel (A).
   
   
   
   Fig. Remove the crash pad lower panel (A)
4. Remove the 2 screws (A) and the trip switch connector.
5. Remove the crash fascia panel (B).
   
   
   
   Fig. Remove the crash fascia panel (B)
6. Remove the screw with the ignition in the ON position (IG ON) and disconnect the 6P connector.
7. Remove the ignition switch (A).
8. Installation is the reverse of removal procedure.
   
   
   
   Fig. Remove the ignition switch (A)

Specific to:
Hyundai Accent 2006-2008
Hyundai Azera 2006-2008
Hyundai Elantra 2006-2008
Hyundai Sonata 2006-2008
Hyundai Tiburon 2006-2008

1. Before servicing the vehicle, refer to the Precautions Section.
2. Remove or disconnect the following:
   
   The negative battery terminalThe crash pad lower panelThe ignition switch after loosening the screw with IG ON and disconnecting the 6P connector
3. Installation is the reverse of the removal procedure.hope this helps it is off autozone website

Start with the basics - I had a car with this exact problem an the solution was simple - corroded battery terminals. Try cleaning them first if that does not get it try to jump start it or check charge the battery as if the terminals were corroded then it may not have gotten good charge from the alternator. If still no joy then look towards starter motor / solenoid for starter.

disconnect the 2 audio fuses and wiat 5 minutes with the ignition key off, insert both fuses, then turn the key on. if it doesnt eject, it probably has an internal defect and will need to be repaired.

passenger side under the dash

2008?... It's still under warranty.