SOURCE: locassion of output speed sensor on 2003 Town and Country
The input and output speed sensors look identical on the connector side. The one over the solenoid pack is the input, the one closer to the left frame rail or left front wheel is the output sensor. I hope this helps.
SOURCE: illustrated diagram on how to remove speed sensor for windstar 98
The Vehicle Speed Sensor is located on transaxle, at the rear of the engine. I would check the harness connector to be sure it is clean and connected tightly. Also check the wiring for cuts and chaffing. Since it is fairly inexpensive, only about $42.00 from Ford, you may want to consider replacing it, at least to eliminate it as a possibility. You may want to go to a muffler shop to have this done like speedy, I believe the flex pipe needs to be undone to get to the VVS. If there is an Auto Zone around your area, you could always ask them for the step by step instructions to replacing the VVS, and it's free of charge. Good luck and hope this helps.
SOURCE: Dodge Durango 1998 5.2L Output Speed Sensor code P0720 Location
Its in different locations depending on if its 2wd or 4wd. For 2wd its in front of the drice shaft or for 4wd its in the tranfer case, just look for a white shape like box with wires plugged into it and you need a socket to remove it, iam not sure how much it is to replace as the cost varies at different shops.
SOURCE: I need to replace the transmission speed sensor
usually they are at the back of the tranny with a 2 wire plugin and one bolt holding it in...if not it may be part of your rear ABS sensor in your rear end...do you have any codes about ABS
SOURCE: i have a 1996 dodge caravan with the 3 speed
A 3 SPD TRANS DOES NOT HAVE INPUT/OUTPUT SENSORS..ONLY A VEHICLE SPEED SENSOR..IT IS LOCATED ON TRANS EXTENSION HOUSING WHERE RIGHT SIDE AXLE COMES OUT OF TRANS..1 BOLT AND A WIRE CONNECTOR
27 views
Usually answered in minutes!
×