SOURCE: transmission stuck in third gear when selector in
The problem is most likely an input or output sensor on the gearbox. I tried changing the transmission oil which worked for a few weeks and the problem started again. I also tried removing the sensor and wiping them which also worked for a little while. In the end I bought a second hand sensor from a wrecker for about $60 and no problems for the last 4 months. You can find them online as a set for about $150 new but I have a little bit of scottish in my blood. There are a few posts on the web about how to change the sensor. It takes about 20 mins for a handy person and it took me about a half hour.
SOURCE: logbook service for a hyundai getz
hi from uk did you not recieve the wallet containing the owners handbook/service reciord book/ radio instructions book? this comes with car if you bought new ? check with dealer and ask for it? there is a market for these books and are valuable yours may have been taken ??
SOURCE: Here are the issues with my 2000 Subaru Legacy L
These assorted problems usually come from the control modules, in this case the transmission control module (TCM)
First, reset al ECM' by removing the battery negative terminal for a minute or so then re-fit it. This reset should cure all your problems. If not I shall consult my TSB's after you post the results of the reset.
SOURCE: What automatic transmission fluid to use for Hyundai Getz 2008?
please read your instr. manual download from www.fitness.manualsonline.com or www. retrevo.com or ask to your mechanic what oil trans you need.
God bless you
is no need to match colors. Try by using a tester and see which wire is earth,signal and play with it. Confirm whether it is the right part first.
REMOVAL AND INSTALLATION (Continued)
Gear Shift - Floor Mounted
Removal
1. Raise the vehicle and disconnect the transmission
shift cable from the lower selector lever.
2. Disconnect the four nuts that attach the housing 6. Remove the whole floor shift housing by lifting
to the floorpan. vertically
Installation
1. To install the floor shift housing to the floorpan
reverse the above instructions in order 6, 5, 4.
2. Place the selector lever in the 'P' position.
3. Raise the vehicle.
4. Reconnect the four nuts that attach the housing to
the floorpan.
5. Install the shift cable back onto the lower selector
lever.
6. Tighten the lock nut to the required torque to 28
Nm.
7. Lower the vehicle and check transmission
operation in each selector lever detent position.
3. Lower the vehicle. 8. Check that the mode light functions correctly. For
4. Remove the centre console (Refer to section further information, refer to Section 307-05.
307-05).
5. Detach the back light bulb/wiring.
BF00006
I6 Floor mount shift components
183 views
Usually answered in minutes!
×