Do you take valve body out to replace it
SOURCE: 2002 Sunfire TCC Solenoid replacement
hi..the transaxle converter clutch . tcc. uses a solenoid -operated valve located in the automatic transaxle to mechanically couple the engine flywheel to the output shaft of the transmission through the torque converter.that reduces the slippage loss in the converter.reducing emissions.but check the vss first.which is called the vehicle speed sensor.they both work together .if the vss is not working right it wont call on the tcc.
check this out..
thank u..
rate me..
SOURCE: IAC Valve Location - 1996 Jeep Grand Cherokee
The idle air control valve is located on the back of the throttle body. It has an oval electrical connector and two torx screws holding it in. Unplug the connector, remove the two screws then lightly tap the body with a soft faced mallet to loosen it from the body.
Once you have it out and prior to installing a new valve clean the seat inside the throttle body where the idle control fits. This must be very clean! Installation is in the reverse order.
To save some cash, pull the valve out and clean it with throttle body cleaner, this usually fixes the problem for quite a while.
Good luck and hope this helps.
SOURCE: replace fuel filter on 1997 jeep grand cherokee
If you have the V8 engine, the filter is actually part of the fuel pump. WHICH IS IN THE TANK
SOURCE: HOW TO REMOVE HEADLIGHT ASSEMBLY 2006 JEEP GRAND CHEROKEE
remove the 7mm bolt in the centre top of lamp unit then with a big screwdriver just behind headlamp prise outwards quite firmly
SOURCE: how to replace 2006 Jeep Grand Cherokee fan Heater
the blower motor is under panel near glove box. remove connector then the 3 mounting screws that hold it in. if changing the motor, use old fan cage from blower to new one, remove retainer clip to take off of motor shaft. CARL,
It is located in the transmission under the valve body cover on the drivers side of the transmission. It is the solenoid on the bottom left hand side of the valve body. I had to take the suspension and frame support off and lower the transmission before I could remove to valve body cover. A retainer clip holds the TCC solenoid in place.
Thanks.
347 views
Usually answered in minutes!
×