I would like to do it my self to put on a head and a 2003 honda accord how much do you give the head bolt
Find it on this site
https://www.felpro.com/technical.html
SOURCE: Connector for Speed Sensor on1996 Honda Accord Auto Trans.
If you are talking about just plugging into the speed sensor yes. A VTEC and NON-VTEC are one and the same.
SOURCE: Determining if head gasket is blown on a 1994 honda accord Ex w VTec
White smoke out of the exhaust is one indication that the head gasket is blown. Another is to start the car and check the oil on the dipstick. If it's frothy or looks like a milkshake, this is another indication of a blown head gasket. The milky appearance indicates that coolant is in your engine, caused by a bad head gasket. If none of these symptoms occur, then the problem lies elsewhere. Hope this answers your question and feel free to post back with any other concerns or questions. Thank you.
Greg
SOURCE: head bolt torque specs for 200 honda accord 3.0
its a three step process 1st 29ft/lbs 2nd 51ft/lbs 3rd 72.3ft/lbs
SOURCE: torque specs for head bolts
Hello joee105,
The head bolt torque is a three step procedure:
1. 29 ft. lbs.
2. 51 ft. lbs.
3. 78 ft. lbs.
See image below for torque sequence.
I hope this helps.
Regards,
Jerry
Install the cylinder, then tighten the cylinder head bolts sequentially in 3 steps. step 1. 29 ft. lbs. step 2. 51 ft. lbs. step 3. 72 ft. lbs.
157 views
Usually answered in minutes!
×