Squirt some starter fluid into the throttle body. If it starts then you have a fuel problem. If it does not, check to see if you have spark to the plugs. Check the injector fuses.
SOURCE: Isuzu 1997 KB 260 Workshop Manual
try haynes.com or your local parts store for a Haynes manual. For around $20 they are frequently as good or better for home mechanic than factory manuals for $100.
SOURCE: 99 ram diesel wont start
Did you check to see if there is power to the glow plugs if not then that may be the problem and if there is power when you cycle the key not to start but for the plugs to warm up you may have a bad glow plugs.
SOURCE: '95 Honda Civic EX will not start after cleaning fuel injectors
I would talk to who cleaned the injectors, I don't know if it something they did or not. It could be a stuck open injector. The exhaust would have a raw fuel odor if it was. What it sounds like is a blown headgasket, which can just happen. The exhaust would have a sweet smell to it. Usually starts as a small leak (between cyl. 2 & 3), the engine burns the coolant while driving which you don't see. Then the coolant level gradually drops to a point where the car overheats, which warps the head, causing a large leak. Now you see the coolant burning (white smoke).
Good luck Honda Al
Testimonial: "Thank you so much for your help. I did find out the problem. I had a bad distributor cap and rotor. Got it fixed and now the car runs fine."
SOURCE: 2000 vw cabrio runs normal and shuts down, takes 5
Did you ever get to the bottom of this problem? My car has the same codes- dealer says it might be the fuel pump relay. Wondering what you found out?
SOURCE: Isuzu 4JX1 EngineWont Start after replacing new injector
my isuzu bighorn will not start after changing valve seals and head gasket and after setting timing it still will not start. do you have a solution.
134 views
Usually answered in minutes!
×