O reset the system, first make sure the tire pressures are correct. Turn the engine on, then press and hold the reset button. You'll find it low and to the right of the steering wheel on the instrument panel. Hold the button down until the TPMSindicator light in the instrument panel blinks slowly 3 three times.
SOURCE: 2013 dodge journey seatbelt wrapped around headrest and wont release
Remove the cover over where the belt goes into, use a screwdriver to unjam the "cogs" thus releasing the belt. Replace the cover. That should fixya
SOURCE: How do I reset TPMS light focus 14
Use this if you're installing winter wheels/tires that have sensors already installed, or even if you are just doing a tire rotation. Not sure if this has been posted before. I tried searching but didn't see it posted anywhere. No need to go and buy the TPMS learning tool.
1) Make sure your tiresare inflated to the recommended psi. Mine is 40psi.
2) Turn ignition to the on position. If you have a push button start, push the start button without pressing the brake pedal.
3) Push the hazard light button 6 times. The horn should honk and you should see "Train left front tire" in the LCD display between the tach and speedo.
4) Release air pressure in the front left tireuntil you hear the horn honk. The LCD display should now read "Train right front tire".
5) Release air pressure in the right front tire until you hear the horn honk.
6) Repeat for the the right rear tire, and then the left rear tire.
7) You should now see "Training Complete" in the LCD display.
8) Fill your tiresback up to the recommended pressure.
Enjoy!
Push the uconnect button and at the same time when the voice
says uconnect ready adjust the volume knob
SOURCE: My 2013 Dodge Journey stalls with no warning while driving
try reading this link.. Why Does My Car Stall While Driving
2,494 views
Usually answered in minutes!
×