This manual has a lot of information. I hope it has yours.
http://olybrake.com/pdf/fel_pro_torque_specs_guide.pdf
SOURCE: cylinder head torque settings 1990 2.6L isuzu motor
From front to back is this:
7 3 1 5 9
8 4 2 6 10
First torque value is 58 ft lbs.....then final torgue is 72 ft lbs.
SOURCE: Torque specs for mighty max
Per my Chilton's manual tehe bolts should be (cold engine) 65 to 72 FT. Pnds., the cam shaft bearing bolts should be 8x25 = 15 - 19 Ft pnds and the 8x65 should be 14 - 15 Ft Pnds.
The sequence is as follows for the (10 ) head bolts:
7 - 5 - 2 - 4 - 10
9 - 3 - 1 - 6 - 8
I hope this may help,
Tom
SOURCE: i need the engine torque specs for 99 chevy malibu
99 chevy malibu v6 3.1 engine, head bolt torque is-- 98 through 2001 is step1- 37 foot lbs, step 2- rotate an additional 90 degrees (1/4 turn). the rocker arm bolts are 168-in. lbs.
SOURCE: My Mitsubishi colt CZ1 (07
Central locking works by way of little electric motors that engages and disengages the door lock. The drivers door has an additional set of contacts in the actuator which signal the controller when it changes position. The controller activates the servo motors when a signal is received from the receiver or from the drivers door servo motor. So in your case I suspect the motor part of the drivers door actuator is done for.
To replace you will have to remove the inner driver's door panel to get at the actuator. The actuator itself cannot be repaired and needs to be replaced as a unit.
Testimonial: "Very helpful answer and a prompt response. Thanks"
157 views
Usually answered in minutes!
×