The navigation system in my 2014 dodge journey with 8.4 screen says loading maps and doesn't do anything

Question edited for clarity.
Question moved to model category.

One on each bank

Camshaft position sensor - Engine & Transmission

Dodge Journey Forum https://www.dodgejourneyforum.com > topic > 5405-...
Feb 21, 2014 - The Camshaft Position (CMP) sensors are located at the rear of the cylinder head covers and are bolted to the cylinder head. Disconnect and ...

3.5L Camshaft position sensor - Dodge Journey Forum
6 posts
Feb 23, 2017
Crankshaft position sensor - Electrical, Battery & Charging
8 posts
Jul 1, 2016
Camshaft position sensor bank 1 - Dodge Journey Forum
3 posts
May 4, 2020
2014 Dodge Journey Cramshaft and Crankshaft Sensor
7 posts
Jan 4, 2018
More results from www.dodgejourneyforum.com ..

There isn't one. The alternator SUPPLIES power, it doesn't use it.

Fuse Box Diagram Dodge Journey (2011-2019) - Fuse-Box.info

fuse-box.info > dodge > dodge-journey-2011-2018-fuses

Fuse box diagram (location and assignment of electrical fuses) for Dodge Journey (2011, 2012, 2013, 2014, 2015, 2016, 2107, 2018, 2019).

You must give phone to any expert

Try this youtube video. Hope this helps https://m.youtube.com/watch?v=SJKRr2V8spo

Help with heating issues, blend actuator - Interior - Dodge ...

www.dodgejourneyforum.com/.../5304-help-with-heating-issues-blend-a...

Jan 13, 2014 - My 2009 Journey R/T is only blowing hot air out the driver side vents, while the other vents (passenger and rear) are blowing cold air ... Thanks Frogbox....keep in mind that the info is for the 2009 model and I guess it also applies to2010's. 2009 journy sxt heat/cool issue
Oct 16, 2014
Air Conditioning?
Dec 22, 2012
Rear heater A/C
Dec 22, 2012
More results from www.dodgejourneyforum.com

In a 2010 dodge journey why heat comes out just one side

2013 Dodge Journey ' Gas Cap Message - YouTube

? 0:41
www.youtube.com/watch?v=l3cjMwqx5Ko
Dec 3, 2012 - Uploaded by Mopar Brand
This video explains what the gas cap message means in the 2013Dodge Journey. ... Replacing gas cap after Check Engine lightcomes on. - Duration: 2:50. by ... 2014 Dodge Journey AWD Review: Is this really a Man Van?

You will need to go to the dealer for a software update,the RA4 has a recent update that may address this issue and the dealer may be the only way to get it.Go to the system info on the radio and see if the software version is at least 14.0. if it's 13.48???? it needs the update

Sounds like a common issue that has been happening on the2011 Dodge Journey's. It is covered under warranty and is advised you do not try to fic it yourself. You may void the warranty trying to fix it yourself.

Installing the DVD Map Disc Your dealer/retailer may have installed the map DVD. If the map DVD was not installed, do the following to load it:
Read the following steps completely.

1. Turn the ignition on. The vehicle must be in P (Park) to perform this operation.
2. Press (power) to turn the navigation system on.
3. Press the NAV hard key.
4. Touch the Insert Map Disc screen button. The screen opens to access the map DVD slot.
5. Load the map DVD partway into the slot. The system pulls it in. The screen cannot be closed until a double beep is heard.
   Notice: Pressing directly on the navigation screen may cause damage. Repairs would not be covered by the vehicle's warranty. Do not press directly on the navigation screen.
   
6. To close the screen, slightly push up on the two outer corners until the screen is in position. Then push the screen in by pushing on the four outer corners until a click is heard.
7. Set the search area. See "Setting the Search Area" earlier in this section.

Ejecting the DVD Map Disc The navigation portion of the system cannot be used if the DVD map disc is not loaded.

1. Press the MENU key to enter the Menu options, then press the MENU key repeatedly until Nav is selected or touch the Nav screen button.
2. Touch the Map Database Information screen button.
3. Touch the Eject Map Disc screen button. The screen tilts, exposing the map DVD slot.
4. Press the eject button, located next to the DVD map disc slot, and the disc ejects. Pull the disc out. The screen cannot be closed until a double beep is heard.
   Notice: Pressing directly on the navigation screen may cause damage. Repairs would not be covered by the vehicle's warranty. Do not press directly on the navigation screen.
   
5. To close the screen, slightly push up on the two outer corners until the screen is in position. Then push the screen in by pushing on the four outer corners until a click is heard.