Bonjour je vien de r?soudre un probl?me de ESP BAS sur mon Dodge chargeur 2009 3.5l police pack.Quand je met mon clignotant a gauche et je tourne a gauche la lumi?re ESP BAS s'allume.aussi Javais un probl?me avec ma valise elle n ouvrais plu tout etais reli?e les files etais coup?e au niveau du gros caoutchouc qui suppos?ment prot?ge les files qui est situ?e entre la porte de la valise et la valise.A la longue a force d'ouvrir et ferm? les files ce sont couper.
Go to www.300cforumz.com(threads)
SOURCE: ABS and ESP BAS is turned on and the fault
C1041 code is-Left Front Tone Wheel Performance
the speed sensor was slower then the other front one to react to something,or the left wheel spun and not the right front one,
or there is a problem in the sensor or wiring
SOURCE: the ESP/BAS light keeps coming
Have you unhooked your battery for something? You might try making sure the stability control's steering sensor is correct...
Basically, start the car turn the wheel all the way left to the stop, all the way right, then back to center. This lets the stability control know where "center" is.
Try this:
1) Disconnect your battery, wait 1 minute & just turn on the lights for a second as to remove any residual current from the computer.The lights will not come on but still turn ON.
2) Re-connect the battery, this should have cleared all of the lights except for the ESP\BAS light.
3) Start the car, center the wheels, turn all the way to the left then all the way to the right. This should clear the ESP\BAS light.
-------
If still the same problem then the esp/bas module needs to be checked and reprogrammed by the dealer to turn it off.
Thanks. Keep updated for any more query. You can rate this
solution and show your appreciation
SOURCE: ESP/BAS warning light on. went
Hi, these systems are all linked together. Most commonly, one of the wheel speed sensors is not reading or is reading incorrectly. This can also occur on slippery surfaces where one or more wheel slides enough to cause the sensor to drop the signal, but not enough to meet criteria for an abs or esp episode. If the light comes back every time you turn on the ignition, there is a deeper problem.
The system has detected a fault in the electronic stability program - brake assist system. You have an electrical connection at the rear wheels secured to the inside of the brake area and are viewable from under the vehicle. It is a small wire harness running to each wheel. Grab the connector and wiggle it around, and make sure they are tight. Due to the connector being mounted low to the ground, sometimes they become dirty or corroded, not making contact. Do this on both sides and see if the lights turn off.
If the light does not turn off, you have to replace dynamics sensor, which is mounted UNDERNEATH the center console in the car. There is a "lost communication to dynamics sensor" and "low voltage to dynamics sensor supply"..
SOURCE: 2008 dodge charger ESP/BAS and traction light on
Have the brakes inspected for worn out brake pads causing a metal to metal scrape of the pad and brake rotor.
1,691 views
Usually answered in minutes!
×