Brakes binding can be the pistons sticking. this could be down to the brake fluid is old and has water in it or the pistons have a coating of rust on them, if you dont want to remove them you will need a meta space and fit this in were the disc and brake pads fit but it needs to be 8mm thicker than the combined thickness of all 3 fitted, and then pump on the brake so the piston is out and then clean it with a wire brush. and brake cleaner. push it back in and do the same again till its free. making sure there is enough brake fluid in the system, only do one wheel at a time. before refitting clean the runners on the brake pads location and the run liners. and use copper grease on all moving parts on the brake runners and the back of were the parts contact each other. one wheel at a time and remove disc and clean with wire brush and drill remove rust and wipe clean with brake cleaner.
417 views
Usually answered in minutes!
×