SOURCE: 2003 nissan altima 2.5s transmission rough shift
Probably sensors! I have already replaced the crankshaft positioning sensor once, nissan replaced it once under recall and now it is bad again! Plus my speed sensor is bad too! Go to any part store and get diagnostic test ran, it will tell what sensors are bad.
SOURCE: 2004 nissan altima transmission
Check the Transmission Fluid. If you Transmission fluid is ok than its you Transmission is bad.
SOURCE: 2003 Nissan Altima 2.5 transmission
The 2.5 and the 3.5 transmissions are the same except for the side cover where the output gears are. The 3.5 uses thicker gears. They were made in Decherd Tn. Also the bell housing is different. The starter for the 3.5 is mounted in the bell housing and the starter for the 2.5 is mounted to the block.
SOURCE: 2002 Nissan Altima 2.5 s transmission won't shift out of 1st gear after being replaced.
sensor plug with white band goes to the outside sensor, they will plug in wrong and cause the same sympyom
SOURCE: how to remove the transmission on a 2004 Nissan
you want the 50 steps?
get and FSM
or alldata.com
i bet nobody posts all 50 steps.
139 views
Usually answered in minutes!
×