SOURCE: change spark plug wires on 04 kia sedona
REMOVAL OF THE PLUGS:
Do not attempt any maintenance on spark plug if engine is hot.
1. Disconnect negative battery terminal.
2. Carefully remove high-tension leads.
3. Use compressed air to blow any dirt or debris from around spark plug hole.
4. Check that spark plug fits squarely in spark plug socket and remove spark plug.
Raise a vehicle and install SST(OK552 131 001) in order to replace cylinder 2, 4, 6 spark plug.
INSTALLATION:
1. Install spark plug into cylinder head.
Tightening torque : 18~22lb-ft (25~30N·m, 2.5~3.0kg-m)
2. Reconnect high-tension leads.
3. Reconnect negative battery cable.
Hope this helps and simple to understand. Good luck
SOURCE: oil filter location for KIA Borrego 3.8 for filter
This is for a 96' , 3.8L but it's all I could find, but will check again if no help. Let me know.
SOURCE: Oil Filter Location on 2009 Kia Borrego W/3.8 ltr
nazof is exactly right. Totally disregard emissionwiz and clint_carter. I have the exact same vehicle and have changed the oil and filter myself. The filter is located right in the middle, almost up against the firewall, after you pop the plastic engine cover. You must twist off a plastic cap and then pull the filter (a cartridge type) straight up and out. There are two replacement rubber rings that should come with your replacement filter. One goes on the plastic cap (just above the screw threads) and the other much smaller one goes at the end of a plastic rod that is connected to the cap.
SOURCE: need to change back 3 spark plugs on 2001 kia
use a long, spark plug socket,wrench(how can you do a job without the right tools??????like an accountant without a pen......)
1,445 views
Usually answered in minutes!
×