Make sure the 3 prongs (2 silver & 1 gold) line up to connect properly when you put it back in. I had to pullout the gold outside of where the bulb sits and slightly pull out the 3 in the actual lens to get a good connection. ***This is what makes the turn signal wireless... They have to be aligned and have contact****
Make sure the 3 prongs (2 silver & 1 gold) line up to connect properly when you put it back in. I had to pullout the gold outside of where the bulb sits and slightly pull out the 3 in the actual lens to get a good connection. ***This is what makes the turn signal wireless... They have to be aligned and have contact****
×
SOURCE: 2003 Hyundai Tiburon
The tiburon turn signals are controlled by a bcm (body control module) The bcm controls the ground to the signals. These always go bad and cause the signal to stick on or just not work. hope i was a help.
SOURCE: 98 Hyundai Elantra turn signal and hazards only work sometimes.
You need to replace the fuse - have a look at the manual and see which fuse it is buy a new one put it in and it should be fine - the on off thing is where the fuse wire touches and then moves again.
SOURCE: My hyundai elantra 2003 model,hazard signal not
You have two separate fuses. Fuse #1 provides power to turn signals. Fuse #4 provides power to the hazard lamp circuit.
Photo:
Fuse Box
have you tried to see if a fuse has blown? most of the fuse boxes are in side driver side under the dash.they are usually visable you may need a flashlight.usually they are marked what they go to.
3,074 views
Usually answered in minutes!
×