Can't locate fluid eservoir to add trans fluid

The automatic transmission fluid fill location on a 2008 BMW 650i can vary depending on the specific model and transmission type, but generally it is located under the hood and accessed through a dipstick tube.

To locate the dipstick tube for the automatic transmission fluid, follow these steps:

1. Open the hood of the vehicle and locate the transmission fluid dipstick. The dipstick handle is usually yellow, red, or black and is labeled with "ATF" or "trans."
2. Remove the dipstick from the tube and wipe it clean with a lint-free cloth or paper towel.
3. Reinsert the dipstick all the way back into the tube and then remove it again. The fluid level on the dipstick should indicate the current level of transmission fluid.
4. If the fluid level is low, you will need to add automatic transmission fluid. To add fluid, remove the dipstick and use a funnel to pour the fluid into the dipstick tube. Be sure to use the correct type of transmission fluid specified in your owner's manual.
5. Check the fluid level again with the dipstick to make sure it is at the correct level. Add more fluid as needed.

Note: It is important to follow the recommended procedure for checking and adding transmission fluid to your BMW 650i to avoid overfilling the system, which can cause damage to the transmission. If you are unsure about the location of the dipstick or how to properly add fluid, consult your owner's manual or a qualified mechanic for assistance.

It is designed into the trans.With the vehicle running in park,pull out the dipstick,wipe it clean,then reinstall it,remove the stick again and check where the fluid is on the stick.It should be in the crosshatched area when the vehicle is at OPERATING temp.Fill the trans through the dipstick tube.

About 3 1/2 litres is the average amount. Pour slowly 2 - 3 litres and check trans dipstick in Park with engine running..

the transmission fluid goes down the dip stick hole ,either use a small funnel or special tranny fluid refill top up bottle

Hi, follow the detailed instruction below on how to check the Transmission fluid on your Chevy Cavalier 2001.

1. Turn the Cavalier on and put it in neutral. Make sure your hand brake is engaged to keep the car from moving while you work on it. Open your car's hood so that you have access to the engine.
2. Look for your Cavalier's transmission dipstick. It should stick out from the body of the engine, and be clearly labelled as "transmission fluid." Refer to your Cavalier's owner's manual for a diagram of engine parts if you have trouble locating the dipstick.
3. Pull the dipstick out and clean it off with a rag. Reinsert the dipstick and pull it out again. Check the end of the dipstick for your reading; the transmission level will be measured on the dipstick by labels like "low," "medium" and "high." If your dipstick has no fluid on it, it means that your Cavalier is almost out of transmission fluid and needs more. A low reading also indicates a need to add more fluid. If the fluid is low, add a bottle of transmission fluid, available for purchase at auto supply shops. Add fluid and repeat this process until your dipstick shows a reading of "high" or "full."

Vehicle running in Park. A plug has to be removed from the case - front edge of trans case, passenger side, about two inches up from pan rail. If oil trickles out of hole, it is fine. If not, add fluid up on top through the hole (red cap) until it runs out below. Then replace plug before you shut off the vehicle.

Strange I know..... you should see the 02 and up Explorers!! Hate em

Do you have the owners manual?

Trans fluid should be located near the back right side.A dipstick marked tran or transmission.You add in the hole where the dipstick goes.

Some models do not have a dipstick. There is a plug in the back of the tranny that you pull. with the vehicle running in park and the fluid warm, the fluid should be level with the hole. It will drain out if there is to much. The fill is ontop, there is a red plug that is hand screwed in.

this model has a sealed transmission, there is no dipstick, the dealer has a special tool for checking the level at a plug just over the driver side axle.

Dipstick is to the left of the engine. Should be a small yellow dipstick. Add fluid through the dipstick hole. The vehicle should be running when you do this. It is best to have driven at least 20 miles before adding trans fluid so everything has had time to get hot.